Enttec USB + 3ch De...
 
Notifications
Clear all

Enttec USB + 3ch Decoder = Random Blinking?

25 Posts
3 Users
0 Reactions
8,157 Views
Posts: 128
Topic starter
(@vadoo)
Estimable Member
Joined: 19 years ago

I ended up trying Freestyler.

I found that my 3ch decoder worked perfect. The 30ch works also, but the values are backwards. On is off, off is on. And the lights flicker badly as I drag the intensity bar. Also, ch30 stays on.

So it looks like I learned a few things things. Vixen is not working correctly with the Enttec USB Widget. And my 30ch board is not working as expected... I also noticed the smallest chip on the Enttec is getting very hot..


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Vadoo wrote:I also noticed the smallest chip on the Enttec is getting very hot..

Very hot, like burn your finger hot or uncomfortably hot? Burn your finger hot is bad, uncomfortably hot may be OK for something like a voltage regulator.


Reply
Posts: 128
Topic starter
(@vadoo)
Estimable Member
Joined: 19 years ago

On the far upper side of uncomfortably hot.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Vadoo wrote:On the far upper side of uncomfortably hot.

If it's not the FTDI chip, and you didn't get a blister you might be OK if it's something like a voltage regulator.


Reply
Posts: 128
Topic starter
(@vadoo)
Estimable Member
Joined: 19 years ago

Should I restart this thread under the Vixen section?


Reply
Page 5 / 5
Share: