Enttec USB + 3ch De...
 
Notifications
Clear all

Enttec USB + 3ch Decoder = Random Blinking?

25 Posts
3 Users
0 Reactions
8,155 Views
Posts: 128
Topic starter
(@vadoo)
Estimable Member
Joined: 19 years ago

When I "zoom in" tighter the waves look pretty square. I'm connecting to D+ and D- with the scope, so pin 1 isn't used. I've tried connecting the same way to the decoder and no change.


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Vadoo wrote:I'm connecting to D+ and D- with the scope, so pin 1 isn't used. I've tried connecting the same way to the decoder and no change.

No what I'm saying is remove the wire from pin 1 on one side or the other of the DMX cable between the dimmer and the USB dongle.


Reply
Posts: 128
Topic starter
(@vadoo)
Estimable Member
Joined: 19 years ago

I've tried connecting pin 1 at the Enttec but not at the 30ch decoder. I've tried connecting pin 1 at the 30ch decoder but not at the Enttec. And I've tried not using pin 1 on either side. To change :/


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
Vadoo wrote:I've tried connecting pin 1 at the Enttec but not at the 30ch decoder. I've tried connecting pin 1 at the 30ch decoder but not at the Enttec. And I've tried not using pin 1 on either side. To change :/

OK so its not a ground loop then. At this point I would suggest using a different DMX dimmer to eliminate a faulty dimmer as the source. Doing this would at least prove that the dongle is working right.


Reply
Posts: 128
Topic starter
(@vadoo)
Estimable Member
Joined: 19 years ago

I've done that as well. I have a 3ch decoder that does the same thing. So three different devices, including the scope, connected to the Enttec individually, show the same exact problem. So the problem is coming from through the Enttec, but is it coming from the Enttec? Could it be a driver or port settings issue? I think I've eliminated software and PC issues testing with three different installs on two different PC's.

Next I'm going to take out my old prop controlled board which uses the same DMX plug-in and see if its having any problems. I haven't researched it yet, but whats the difference between what input a set of shift registers look for and what these DMX decoder boards look for? Any chance I could try driving them with my propeller board (which is currently configured to drive shift registers)?


Reply
Page 3 / 5
Share: