e 682 problem
 
Notifications
Clear all

e 682 problem

23 Posts
7 Users
0 Reactions
10.2 K Views
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

Thank you. All five leds on on

Sent from my iPhone using Tapatalk


Reply
Posts: 297
(@emkllk)
Reputable Member
Joined: 15 years ago

Hmm - Any luck with the test patterns?

Sent from my iPhone using Tapatalk


Reply
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

Not able to access the page. On it now

Sent from my iPhone using Tapatalk


Reply
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

Says server is not responding

Sent from my iPhone using Tapatalk


Reply
gassy
Posts: 548
(@gassy)
Honorable Member
Joined: 17 years ago

Any luck getting connected? Have you changed the firmware on the 682


Reply
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

Thanks for all the help. It does seem to output now but not sure if the colors are good. Controller is still in the yard. Not sure if weather is the culprit. Will check in the night. Thanks much EMK, Jcook and gassy.

Sent from my iPhone using Tapatalk


Reply
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

Gassy I have not changed the firmware. Do I need to. Right now my challenge is to acesss the San devices page. Typing the IP of 682 is not taking me to the set up page.

Sent from my iPhone using Tapatalk


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

if it is getting to cold out maybe put a bulb in the case to try and help keep it warmer have seen this posted several times by others

ranjanpa wrote:Thanks for all the help. It does seem to output now but not sure if the colors are good. Controller is still in the yard. Not sure if weather is the culprit. Will check in the night. Thanks much EMK, Jcook and gassy.

Sent from my iPhone using Tapatalk


Reply
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

Checked the outputs from the test page. All fine now. Guess cold weather hurts the electronics too.

Sent from my iPhone using Tapatalk


Reply
Posts: 127
(@kreeve)
Estimable Member
Joined: 11 years ago

From what you have said my first trouble shooting would be power.
#1 verify 12 volt power cable is good to the 1.2 that is not working.
# 2 use a digital volt meter to test the voltage at the connector on the E682. Verify fuse.
#3 Run test patterns as advice given above. You do this by browsing to the set-up screen of the controller. Same place you went to set up the controller to begin with.
That is the #1 thing I have done first when something goes wrong. That first verifies if the issue is at the controller or somewhere else.


Reply
Page 2 / 3
Share: