e 682 problem
 
Notifications
Clear all

e 682 problem

23 Posts
7 Users
0 Reactions
10.2 K Views
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago
[#44175]

Yesterday night channels 1 to 8 of my e682 matrix stopped outputting lights. It hs been working fine for two seasons.

We are having sub zero weather in chicago these days. Could this be a reason.

How do I resolve this. Anyone with prior experience. Thanks in advance, an worried about the show now.


22 Replies
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago

do you have two different power supplies for your E682? 1-8 is one half of the board, sounds like a power issue. If you have power to the terminals check the power at the big diode next to the power connector. If it went bad you want have power to that side of the board.

Are your power supplies in the same box as the e682? the heat from them would help in your situation. Electronics only like to get but so cold. Do you leave them power all the time? I run 7 E682 and I leave them powered the entire season.


Reply
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

Thanks Cook. You have such an impressive show.

I have only one power supply into the e682 powering the entire board. The power supply is not located in the same box.

I was worried of leaving them powered on all the time but seems like you have no issues with that.

I will now have to yank the controller out from the freezing yard to do the diagnosis. Is it likely that any fuse if blown off - if there is one which powers one half of the board. Thanks


Reply
JCook
Posts: 1003
(@jcook)
Noble Member
Joined: 13 years ago

take a picture of it powered before you take it out.

What LEDs are on?


Reply
Posts: 31
Topic starter
(@ranjanpa)
Eminent Member
Joined: 10 years ago

All the four led lights inside the controller are on. Does it mean anything.


Reply
Page 1 / 5
Share: