Hi, we will be releasing the tested 2801/6803 string driver design on Monday. Check out www.response-box.com/rgb for details. PCB only will be available for order. It will drive four separate strings, driven by a DMX input. All other parts are easily obtainable from your favourite supplier.
Construction is in SMD, however the smallest parts are SOIC, so if you've never done SMD, its not something to get too scared about.
Source code will also be avaialble, so this is truely open.
i thought spi was 6meter between chips, or is that between chips an the controller, i was going to run them from phils an tabor tiger pb.
Matt_Edwards wrote:These chips are used in the commercial Pixels. They offer 3 channels of 8bit PMW with programmable constant current source. At a street price of 20cent each they are also damn good value.
I am thinking of a small remote controller
![]()
Basic Spec:
3ch
30mA Constant Current
12 to 24v operation OR
5V only
Parts cost are around 3.00 in PWB but exc the 24 to 5 SMPS. I haven't decided on the PS yet. AND you will need a DMX 2 SPI Bridge with RS422 driver capability.
So any thoughts?
i thought spi was 6meter between chips
I doubt that. it is just a plain digital signal, running at speeds up to 25MHz.
Actually according to the data sheet, SmartAlec is right.
Not specifically about SPI,but in regards to these chips.
Spec say 6 metres at 2Mhz clock rate.
Now whether or not it is possible in real life is another matter.
I imagine a slower clock rate would be required for longer distances.
Tabor wrote:Actually according to the data sheet, SmartAlec is right.Not specifically about SPI,but in regards to these chips.
Spec say 6 metres at 2Mhz clock rate.
Now whether or not it is possible in real life is another matter.
I imagine a slower clock rate would be required for longer distances.
I have done 7m at 1.2Mhz, but its not that tolerant to external noise.

