Re reference charts, nearly all spec sheets should list the hole size that is the finished plated hole, if they show a .040 hole and you place a .040 hole then it should be correct when you get the finshed board back.
If only the lead size is shown or i measure one then i add .006 to that dimension to get the hole size. I usually try and keep as few drill sizes as possible.
As for the ZC resistors i would stand them on end by default as this is good cooling orientation.
I found this note on the ExpressPCB site:
You should leave a .020 space from the fab edge of the board to the nearest copper elements to prevent traces from being cut off and possible mask peeling and exposed copper.
Is it safe/acceptable/good practice for the traces to go that close to the edge? That would save over .5" on this board if I did that, but would it make it harder to home-etch in future?
aussiephil wrote:I usually try and keep as few drill sizes as possible.
Would it be better to make some holes a little larger than needed (say, up to 50% larger?) and then need extra solder to fill them, in order to reduce the number of hole sizes? For example, on this PCB there are several holes for jumper wires that I made smaller than the default sizes on pre-defined components because those seemed too large, but maybe I should just use that same size for the jumper holes also?
don
djulien wrote:
If I am charlie- or chipi-plexing the SSRs so that one of the I/O lines would be acting as ground, would a true ground still be needed for other purposes such as to reduce interference or to balance the twisted pairs?
I wasn't considering that you were using charlie-plexing, so the grounds are not needed from a functional point of view. They are not needed for balancing the twisted pairs, especially since charlie-plexing doesn't drive the wires in a paired fashion. And for reducing interference, I don't know, since nobody here does any systematic testing for interference.
Is that due to their sizes/shapes, or that the actual layout order with respect to direction of current flow is important?
(Referring to the caps by the regulator). It appeared to me that you wanted the option of powering the board from a low-voltage AC source, based on the full-wave bridge rectifier circuit. If so, you need a big enough cap on the input to the regulator to ensure that the input voltage to the regulator does not dip below the regulator's dropout voltage. If you are always using a DC power source then this is not a consideration.
Is it safe/acceptable to turn these resistors "on end" to take less space, or should they always be parallel to the board surface?
This doesn't matter, in my opinion. Way back when the design rules called for the resistors to be flat on the board so that they could be automatically inserted with the equipment in use at the time. Since the resistors are going to be hand-inserted, I don't think it matters if they are "on end" or not, unless you are worried about accidental damage later on.
P. Short wrote:(Referring to the caps by the regulator). It appeared to me that you wanted the option of powering the board from a low-voltage AC source, based on the full-wave bridge rectifier circuit. If so, you need a big enough cap on the input to the regulator to ensure that the input voltage to the regulator does not dip below the regulator's dropout voltage.
Whoops. Yes, I forgot to add a big capacitor to smooth out the rectified AC. Those caps are usually pretty big, so I guess I need to move stuff around. Maybe I can squeeze it in just after the diodes. Does it matter how close it is to the regulator?
don
That should be OK.
