Super Strip Flood C...
 
Notifications
Clear all

Super Strip Flood Controller

240 Posts
30 Users
0 Reactions
91.6 K Views
Posts: 1041
(@christmas-light)
Noble Member
Joined: 18 years ago
budude wrote:That's cool - what is the regulator module you are using? Might want to add this to the Wiki as another option if viable. The new board prototypes are being built as I type so hopefully the new version will be out shortly and get in your hands in time for the show!

btw - that desk is entirely too neat/clean - disgraceful! :rolleyes::p

LOL 😀 (It is just because it is a new one 😉 )

I use this reg:

Link


Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago
christmas-light wrote:LOL 😀 (It is just because it is a new one 😉 )

I use this reg:

Link

OK - just a regular 7805 setup - does it get very warm? I'm guessing it does - a full 48-channel sequence pulls just under 400mA.


Reply
Posts: 1041
(@christmas-light)
Noble Member
Joined: 18 years ago
budude wrote:OK - just a regular 7805 setup - does it get very warm? I'm guessing it does - a full 48-channel sequence pulls just under 400mA.

Hmm

well I can not tell you because I only tested 15 ch at on at one time, but when I did that I could holde on the heatsink without burning my fingers 😆

But if the board is only drawing 400 mA then it should work fine because there stands that it can handel 1 A


Reply
budude
Posts: 10400
Topic starter
(@budude)
Illustrious Member
Joined: 18 years ago
christmas-light wrote:Hmm

well I can not tell you because I only tested 15 ch at on at one time, but when I did that I could holde on the heatsink without burning my fingers 😆

But if the board is only drawing 400 mA then it should work fine because there stands that it can handel 1 A

Yes - but it's also dropping lots of voltage which equates to a lot of power which equates to a lot of heat - that is the problem oldcqr found that prompted the new layout. Because you're only running 15 channels you'll probably be fine.


Reply
Posts: 1041
(@christmas-light)
Noble Member
Joined: 18 years ago
budude wrote:Yes - but it's also dropping lots of voltage which equates to a lot of power which equates to a lot of heat - that is the problem oldcqr found that prompted the new layout. Because you're only running 15 channels you'll probably be fine.

I can´t say if it is right or left (not) 😆 because I have never been working with that 😛

but it is working fine for me and I am glad 😉

C - L


Reply
Page 47 / 48
Share: