SNUBBER Solutions ?...
 
Notifications
Clear all

SNUBBER Solutions ??

26 Posts
10 Users
0 Reactions
20.9 K Views
griffixdc
Posts: 2512
Topic starter
(@griffixdc)
Famed Member
Joined: 16 years ago
P. Short wrote:A parallel resistor.

so then that goes back to the orginal 'SNUBBER" idea ...except i think some capacitance and transients feed back through other channels as well so shouldn't there be another diode placed in series (on the other channels only with LED strings )


Reply
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

C9 Bulb... A Glade Plugin.. A resistor across the output. There have been several things done and have worked for several people.. when you get boards "if" you have a problem experiment then.. up until that point you'll never know if it's going to happen with your situation.


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

As mentioned "SNUBBER" is/was probably not the best choice of words for this since it's normally thought of with motors or relay coils to kill the inductive kick from them. This is not really the same thing but the name for this idea has become common...


Reply
griffixdc
Posts: 2512
Topic starter
(@griffixdc)
Famed Member
Joined: 16 years ago
budude wrote:As mentioned "SNUBBER" is/was probably not the best choice of words for this since it's normally thought of with motors or relay coils to kill the inductive kick from them. This is not really the same thing but the name for this idea has become common...

correct like i stated earlier its actually not a snubber...a snubber stabilizes the voltages . i just use that term because people are familiar with it :)..... the main idea of this thread was to add ideas to my original ideas or to test my ideas to see if they help people that have trouble (after they already included that resistor) 🙂 thanks for all your input (all of you )


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago
griffixdc wrote:so then that goes back to the orginal 'SNUBBER" idea ...except i think some capacitance and transients feed back through other channels as well so shouldn't there be another diode placed in series (on the other channels only with LED strings )

I don't know the answer, and I don't think that anybody else knows either.

This has not been approached very scientifically, at least not up the the point that I stopped following that thread on PC. Someone had a problem, looked at some signals with a 'scope, and found an ad-hoc fix for the problem that he encountered. His solution worked for some people, and did not work for some other people. I'm not sure that anybody knows (beyond the buzzword level) why it works for some, and not others. I'm not trying to criticize the people involved, because the problem is difficult and expensive to solve. I'm just trying to point out that the problem is not simple. I think that it is likely that there are several different causes (due to varying LED string designs, varying SSR designs and component selections, and other unknown factors), and that solving all of the problems would likely involve travel by someone with the right skills. Not easy, imo.


Reply
Page 5 / 6
Share: