Mactayl wrote:I have had no luck using MPLabX,, I am using MLab IDE 8.73 and it works fine... did you use the hex file that I added to file library last night named
http://doityourselfchristmas.com/forums/dynamics/showentry.php?e=106&catid=6 and are you using a PIC18F4520.
What issues did you have with MPLabX? I didn't see a download for older versions, but I remember seeing threads where people have mentioned issues with MPLabX. I'm not thrilled with their huge IDE interface and I couldn't get their "IPE" to recognize my pickit2 which is what I was hoping to use for the hex files you've uploaded. Instead I had to create a whole "hex project" in the IDE to get it written, which still didn't work.
Mactayl wrote:make sure you have a shunt accross pins 4 an 5 of JP1 (RenW Header) or it will not work.
DING DING DING!
Reader comprehension fail on my part. I read the first sentence of JP1's description and just jumped ahead since I wasn't using a RenW completely skipping the part that says "If you are not using a XBee Wireless module, the default jumper position is a jumper across pins 4/5."
I now can go through and test everything else, but at least the 1st jack works!
Thank you very much!!
Mactayl wrote:Hi MD,
... did you use the hex file that I added to file library last night named
http://doityourselfchristmas.com/forums/dynamics/showentry.php?e=106&catid=6 and are you using a PIC18F4520.
That just got mine working with a 4525! Thanks Mac!
Greg
Next question. I have JP2 set to 2/3, but a downstream controller (Renard SS8) isn't responding. The PIC for that is set to the same baud rate (57600) and it works fine if I set JP2 to 1/2 (but on channels 1-8 rather than 33-40), so I can rule out some things like solder joints on the jacks, the SS8 not working ,etc. Also, I have the same behavior on two Simple Renard 32s that I'm testing. Everything else appears to be functioning at this point. I suspect I have missed something simple again. Ideas?
Materdaddy wrote:Next question. I have JP2 set to 2/3, but a downstream controller (Renard SS8) isn't responding. The PIC for that is set to the same baud rate (57600) and it works fine if I set JP2 to 1/2 (but on channels 1-8 rather than 33-40), so I can rule out some things like solder joints on the jacks, the SS8 not working ,etc. Also, I have the same behavior on two Simple Renard 32s that I'm testing. Everything else appears to be functioning at this point. I suspect I have missed something simple again. Ideas?
I was right. To originally test I created a sequence with 32 channels. Updated to 40 to daisy chain the SS8, but didn't update the plugin settings. The renard plugin was only sending 32 channels worth of data.
Does anyone have Simple Renard 32 Combo home etch PCB and silkscreen?
