Simple Renard 32
 
Notifications
Clear all

Simple Renard 32

103 Posts
25 Users
0 Reactions
56 K Views
tstraub
Posts: 525
(@tstraub)
Honorable Member
Joined: 18 years ago

Rob,

How are you trying to program this PIC? Through the ICSP header of the SR32 or in a external ZIF socket? Are you powering the chip from the circuit or threw the the PICkit? Most of the trouble I have had programing PICs is related to the voltage on the VSS and VDD pins during programming. I once had a PC that refused to program 18f4520's but would program 16f688's. I finally traced it down to a flaky power supply in the PC. It only had 4.6volts on the 5 volt rail. I swapped out the power supply and its been working great. So if you have another PC it might be worth trying to program the PIC from a different PC.

Tyler


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago
relewis wrote:hmmm - still no luck with the firmware. In fact it seems the chips now wont erase either. Pickit3 me thinks

Don't understand Pickit2 should work just fine,,, only need the Pickit 3 for PIC18F45Kxxxx/PIC18F46Kxxxx devices,, all the PIC18F4xxx should be fine with a Pickit2 programmer. are you using MPLAB or MPASMWIN ?


Reply
Posts: 8
(@relewis)
Active Member
Joined: 15 years ago

I had been using a K149_BC to programme (because it was on ebay and cheap). Have come to the conclusion it wasn't worth bothering with. Pickit3 arrived today and job done in no time. I etched three of these boards last weekend and two are now complete. I made up an interface board to connect one of these to a couple of 16 channel relay boards which i used for this years display and all works brilliantly - 32 channels of really fast clickety clack!
I found the best source for the RJ45 sockets was old 24 port cat5e patch panels.
As this board has just the one status LED I am a little confused as to what the patterns meant. Is there a link to the Status LED decode?
I'm now going to work on some SSR boards and enclosures.
Well done and thanks to everyone involved with this project
Rob

32 channels non-dimmable
64 more dimmable channels in the pipeline!


Reply
Mactayl
Posts: 2491
Guest
Topic starter
(@mactayl)
Famed Member
Joined: 17 years ago

Good to hear you got things going and if you need anything be sure to post any questions you have or PM me.


Reply
glaforce
Posts: 414
(@glaforce)
Honorable Member
Joined: 17 years ago
simple32 done

First one is done.. OK very close someone didnt order the zero crossing opto...


Reply
Page 16 / 21
Share: