Renard Servo PCB Re...
 
Notifications
Clear all

Renard Servo PCB Redraw

18 Posts
6 Users
0 Reactions
9,193 Views
Posts: 44
Topic starter
(@lefty12)
Trusted Member
Joined: 16 years ago
[#15356]

This being my first post, I am not real sure how to begin. I started DIYing my Christmas last year and did a little Halloween display to try and get familiar with the boards and such. Everything went great! So,, I started looking at more things to do especially for Halloween! I ran across Chris Maloney's Renard Servo board and looked into getting some boards made. The board size was just a little bit bigger than one half the mini board pricing size. Soooo I thought I might try to get the board smaller and get two of them on each mini board. Well I have redrawn the thing about two zillion times and each time Chris has been good enough to look it over and make suggestions. I now think I have a board that will work and is only 2 x 2.5 inches!
Now,, I am not much of a pcb designer,, actually dont know anything about it! I just took Chris' design and rearranged the parts.
What I am hoping for is that someone, or a lot of someones will take the time to download this thing and look it over to see if I really messed up on anything. And be kind enough to point them out to me before I order any of them,,

Please feel free to download these files and let me know how it all looks

I have changes the schematic and pcb files to reflect the suggested changes as of 6\12\2011

I have changed the schematic, bom, added excel bom, updated pdf's as of 6/13/2011

Uploaded updated PCB, SCH and BOM files 6/20/11

Randy


17 Replies
Posts: 2215
(@ctmal)
Famed Member
Joined: 19 years ago

Can you add a pdf of the board with the bottom and silkscreen showing(no ground plane). That'll let everyone see the traces.


Reply
mlkren
Posts: 745
(@mlkren)
Prominent Member
Joined: 16 years ago

Here you go.

Update to reflect post #1


Reply
Posts: 2215
(@ctmal)
Famed Member
Joined: 19 years ago

Just as an update...
Randy wanted an Renard Servo Controller layout that he could send out to ExpressPCB to be made. While I was able to help with the general layout, I've never gotten any boards professionally made. I suggested he post his layout so someone with more experience could let him know if they find any snafu's that might cause problems.
With the setup he has now he can use the miniboard option which will allow for 3 boards each with 2 controllers. Each board would have to be cut in half to get 6 controller boards.
Thanks,
Chris


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I would turn U2 180° and remove the capacitor in position C1. There is no thermal pad on the ground pin of J1. It might make it tough to solder, depending on your iron.

The rest looks good to me.


Reply
Page 1 / 4
Share: