Pixel String Data E...
 
Notifications
Clear all

Pixel String Data Extender

32 Posts
10 Users
0 Reactions
17.4 K Views
erm213
Posts: 479
Topic starter
(@erm213)
Honorable Member
Joined: 16 years ago
RPM wrote:With a 7805 you will need at least a 0.33uF capacitor on the input side, so since your diagram shows a .1uF you are OK in that respect.

Wait, isn't .33uF more than .1uf? Should I change it to .33uF?

RPM wrote:Have you worked out any cost estimates to build one of these yet?

I need to update my BOM, and recalculate. It should be $20, or less for a transmitter/receiver pair (based on 1 BOM), plus the cost of the board. Based on the needed components, the board should be small. Hopefully it will be an easy on to etch. I have not looked at PCB costs, as I have not started laying them out yet.

Once I get the schematic solidified, I am going to order a couple BOM's and breadboard everything to prove it out.

Thanks,

Erik


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
erm213 wrote:Wait, isn't .33uF more than .1uf? Should I change it to .33uF?

I'm guessing he was thinking 0.033uF - but the spec sheet does say 0.33uF so you are correct - you should change it...


Reply
RPM
Posts: 1080
 RPM
(@rpm)
Noble Member
Joined: 19 years ago
budude wrote:I'm guessing he was thinking 0.033uF - but the spec sheet does say 0.33uF so you are correct - you should change it...

Yup... my bad. Actually I was thinking 1uF not 0.33uF.


Reply
erm213
Posts: 479
Topic starter
(@erm213)
Honorable Member
Joined: 16 years ago

I have update the BOM I made at Mouser. It can be found at http://www.mouser.com:80/ProjectManager/ProjectDetail.aspx?AccessID=5e059c4617

Currently, it costs $15.98. That included the connectors, of which almost $1 could be saved by soldering the wires to the board. I added a heat sink for both regulators. Not too bad.

I would appreciate if somebody could review the BOM for any errors, omissions, or changes.

Thanks,

Erik


Reply
n8huntsman
Posts: 562
(@n8huntsman)
Honorable Member
Joined: 16 years ago

I wish I was as smart as you guys. It really amazes me when I read this stuff even though I don't really understand it. So what exactly will this thing do? I get the part about having the controller far away from the start of the strings but what's with the 24v stuff? How would that be used?


Reply
Page 4 / 7
Share: