Pixel String Data E...
 
Notifications
Clear all

Pixel String Data Extender

32 Posts
10 Users
0 Reactions
17.4 K Views
erm213
Posts: 479
Topic starter
(@erm213)
Honorable Member
Joined: 16 years ago

I have updated the schematic and the uploaded the revised image.

Erik


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

It would be a good idea to add a capacitor to the input of the LP2950 regulator. The LP2950 does not seem to require the input capacitor, but some potential substitute regulators (such as the MC78L05) will need it.


Reply
RPM
Posts: 1080
 RPM
(@rpm)
Noble Member
Joined: 19 years ago

Personally, I would drop the LP2950 in favor of a standard TO220 case 7805.
Reason being is if you are going to use an input voltage of 24VDC, some of those RS485 IC variants can draw a bit of current and even as shown, if you have a differential voltage of 5V with a 120ohm termination you are going to draw about 40mA per transmitter. The regulator will be getting pretty warm at close to max current output with 24V input.

Just my 2 cents


Reply
erm213
Posts: 479
Topic starter
(@erm213)
Honorable Member
Joined: 16 years ago
RPM wrote:Personally, I would drop the LP2950 in favor of a standard TO220 case 7805.
Reason being is if you are going to use an input voltage of 24VDC, some of those RS485 IC variants can draw a bit of current and even as shown, if you have a differential voltage of 5V with a 120ohm termination you are going to draw about 40mA per transmitter. The regulator will be getting pretty warm at close to max current output with 24V input.

Just my 2 cents

I will change to the 7805. The 2950 was chosen by searching in Mouser for the specs. I am changing the schematic to use the 7805.

Also, I just noticed I should have .1 uf caps on the RS485 ICs on the receiving side as well.

I will update the schematic and upload the latest image when I am done.

Thanks,

Erik


Reply
RPM
Posts: 1080
 RPM
(@rpm)
Noble Member
Joined: 19 years ago
erm213 wrote:I will change to the 7805. The 2950 was chosen by searching in Mouser for the specs. I am changing the schematic to use the 7805.

Also, I just noticed I should have .1 uf caps on the RS485 ICs on the receiving side as well.

I will update the schematic and upload the latest image when I am done.

Thanks,

Erik

With a 7805 you will need at least a 0.33uF capacitor on the input side, so since your diagram shows a .1uF you are OK in that respect.

Have you worked out any cost estimates to build one of these yet?


Reply
Page 3 / 7
Share: