PCB Layout, LED Ano...
 
Notifications
Clear all

PCB Layout, LED Anode Square or Circle Pad?

6 Posts
6 Users
0 Reactions
28.4 K Views
underdog
Posts: 185
Topic starter
(@underdog)
Estimable Member
Joined: 17 years ago
[#15709]

In school I'm sure I learned a rule-of-thumb: "When using polarized components [like LED's], the anode [long leg] is the square pad."

I know their is exceptions to every rule, Teach me!
The question arose when I began assembling the both Chris' Co-op SSRez and Ren64XC. Through assembly of the Ren64 this was true, but when I began the SSR's the "Short not Square" memory trick wasn't true.

Reference's
Strait from the WIKI for SSRez's:

7. Install the Power LED. Orientation is critical. The short leg (the Cathode or K) of the LED must go into the square pad. The silkscreen has this marked with a K

Strait from the WIKI for REN64XC:

-The LEDs are polarized and must be installed correctly. The long lead is the anode and must be placed in the square solder pad. The short lead is the cathode and this is marked on the silkscreen with a "K"

For you fellows that do PCB design, what's the rule? Thanks,

Josh


5 Replies
dmcole
Posts: 2196
(@dmcole)
Noble Member
Joined: 19 years ago

From the ExpressPCB "tips" web page:

Position polarized parts (i.e. diodes, and electrolytic caps) with the positive leads all having the same orientation. Also use a square pad to mark the positive leads of these components.

\dmc


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

I'm probably guilty of not adhering to a rule for this - I tend to rely upon the silk, not the pad type to infer orientation.


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

Conventions are good but not Rules.
On surface mount LEDs, they all get a rectangular pad.
For example, where does the square pad go on back to back LEDS?
Why does the +ve pad on an IC get an ordinary pin and Pin 1 get the Special pad?
And lastly my all time favourite is why we mark the +ve pan on a Capacitor when all caps have have their -ve lead marked?

For me it is far more important to have all the caps with the Polarity in the same direction, all the IC pointing in the same direction etc, but this is near impossible to always achieve.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

LED leg length seems to differ from batch to batch. However using the flat (if it has one) or the flag is far safer.
Also take that forever to test each one before you solder them in. I've read this advice here and it seems to hold true.

Brian


Reply
David_AVD
Posts: 991
(@david-avd)
Noble Member
Joined: 17 years ago
Matt_Edwards wrote:For example, where does the square pad go on back to back LEDS?

If you mean bi-colour LED (inverse parallel connected), I use the square pad as the one which makes the "first colour" emit when that leg is +ve.

eg. Bi-colour LEDs are usually specified as Red/Green (in that word order) for example, so the square pad is the anode when the red part is active.


Reply
Share: