I would tack the chip to the the board first then do the wire, also don't even try to strip the wire just melt the coating off. When i was doing it i was doing a little 5 pin pacakage the size of a 805 resistor.
Also and exacto knife is also a good tool too have for the, so you can cut to length. Also always solder the wire to to the ic then to the pcb, because you have a lower tolerance on the pad.
Ether way yours should be easy compared to this: That a 5pin pinheader next to it. and that is 30awg wire.
And i made a mistake twice on this part... it was cursed second rev below
If you're using a 14-pin PIC, another possibility is to purchase the closest 20-pin part, and cut off the extra 6 pins (7-13). Whether this would work out depends on what features of the part that you're using, and what your time/cost tradeoffs are. For example, if your board was intended to use a PIC16F688, you might use a PIC16F689 instead. The latter part comes in a wide SOIC package, and has the power/ground/programming pins in compatible locations. The downside is that the UART pins are not in compatible locations. If the intended part was a PIC16F1825, you might shoot for a PIC16F1829, which is also available in the wider SOIC package, and is fairly compatible pin-layout-wise with the 1825.
Just a thought if you have some time to order the parts...
Thanks for the pointers. I had planned for the 16F1823, before my little snafu. I looked at the 16F1829, but the SPI lines are in different locations (unless I've misread the Datasheets). I haven't heard back from the PCB Fab, so I'm going to try and barnacle the suckers (once they get here). Worst case, I reorder the boards after I completely trash the first attempt. :biggrin:
P. Short wrote:If you're using a 14-pin PIC, another possibility is to purchase the closest 20-pin part, and cut off the extra 6 pins (7-13). Whether this would work out depends on what features of the part that you're using, and what your time/cost tradeoffs are. For example, if your board was intended to use a PIC16F688, you might use a PIC16F689 instead. The latter part comes in a wide SOIC package, and has the power/ground/programming pins in compatible locations. The downside is that the UART pins are not in compatible locations. If the intended part was a PIC16F1825, you might shoot for a PIC16F1829, which is also available in the wider SOIC package, and is fairly compatible pin-layout-wise with the 1825.Just a thought if you have some time to order the parts...
Thanks for the tips and photo's. I'll post an update once everything arrives and I make my attempt to fix this.
kingofkya wrote:I would tack the chip to the the board first then do the wire, also don't even try to strip the wire just melt the coating off. When i was doing it i was doing a little 5 pin pacakage the size of a 805 resistor.Also and exacto knife is also a good tool too have for the, so you can cut to length. Also always solder the wire to to the ic then to the pcb, because you have a lower tolerance on the pad.
PCB's finally arrived!! (spent a few extra days in transit than normal).
Elecrow boards looks great, and the generously delivered 11 of the larger boards, which I had panelized. So I now have 55 of the 3 channel NRF boards.
Time to get some more parts from Mouser and finally get this project finished. Will post pictures when completed.
