New Controller desi...
 
Notifications
Clear all

New Controller design

131 Posts
26 Users
0 Reactions
44.7 K Views
Posts: 6728
(@p-short)
Illustrious Member
Joined: 19 years ago

Much as I'd like to do some FPGA designing, I don't find that it fits very well with the hobby as it is here. It would end being a force-fit, which would something that I would find hard to be proud of. But it is something in the tool chest that could be brought out when circumstances warrant.


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

Is that your bad case of parsimony acting up there again, Phil?? 😀


Reply
Mactayl
Posts: 2491
Guest
(@mactayl)
Famed Member
Joined: 17 years ago

Most FPGA's and TQFP's have very low current capabilities on there output pins so most of them will need additional buffering on there outputs to drive any type of optoisolator device,, or at at least that is the case with most Microchip devices over 44 pins..


Reply
Posts: 183
(@buckanear)
Estimable Member
Joined: 15 years ago
Mactayl wrote:Most FPGA's and TQFP's have very low current capabilities on there output pins so most of them will need additional buffering on there outputs to drive any type of optoisolator device,, or at at least that is the case with most Microchip devices over 44 pins..

FYI

the Spartan3 series FPGAs can sink and source 24mA. That generally is more than most microcontrollers on the market today. Now the MOC3023M requires only 5mA source current. That is well within the capabilities of the Spartan3A.

Not sure what Altera chips are capable of. Need to research that.

just thinking out loud

james


Reply
Posts: 183
(@buckanear)
Estimable Member
Joined: 15 years ago
P. Short wrote:Much as I'd like to do some FPGA designing, I don't find that it fits very well with the hobby as it is here. It would end being a force-fit, which would something that I would find hard to be proud of. But it is something in the tool chest that could be brought out when circumstances warrant.

That may very well be true. Then again I am a hardware dude more than software. So I tend to be biased a bit.

my motto is why do in software what you can do in hardware. Just the side of the fence I sit on.

just a mere thought or two.
james


Reply
Page 7 / 27
Share: