Joe,
Been a while since I saw a new C++ app. Love it. It brings back so many fond memories of my pre-management days. Just lots of Mt. Dew, Text Editor and compiler.
Ya - now that I'm an old fart and retired - I have time to play and do things my way.
Joe
P. Short wrote:My concern is not so much about the smoothness as linearizing the output. For example, with the current Renard setup and incandescent lights most of the action is at the low end. As you increase the intensity from 0 to 100%, it starts out very dim, and slowly becomes brighter. At some middle range the brightness increases rapidly, and at 75% the brightness has reached maximum value, and (apparently) changes very little as the intensity goes from 75% to 100%. My objective with the 10- or 12-bit dimming would be that the apparent brightness increases 'linearly' as the input values ramp smoothly from 0% to 100%.
Phil,
This reminds me of an article I read about dimming. (It's an old article but I thought it was good.) This may not be the exact answer you are looking for but maybe it will give you a starting point. It describes using a hex table to correct for linear output. There are 2 versions of a hex table given (in figure 4). It also shows a way to do a table lookup on a PIC.
Here is the link:
http://www.tinaja.com/glib/muse109.pdf
There is some related material in these 2 articles:
http://www.tinaja.com/glib/muse108.pdf
http://www.tinaja.com/glib/muse133.pdf
TED
dirknerkle wrote:What was surprizing to me were the numbers of times simple cabling issues came up. And if you spend a few minutes reading through the hundreds of postings related to "controller won't work" or "can't communicate" or "how do I make a cable?" you'll likely discover that making a simple cable with only 2 or 3 connections is more difficult than many new to DIY Christmas lighting can handle. But those folks are exactly the ones who often "go for the big system."http://www.doityourselfchristmas.com/wiki/index.php?title=Troubleshooting/Solutions
Thanks for posting that. Several of the cable problems described in your summary of the survey results were almost certainly caused by using solid core wire. Now I don't mean to insult anyone's intelligence here but I have found that a lot of people just don't get this. Solid core wire is intended to be permanently installed and then left alone. It's not meant to be coiled and uncoiled repeatedly. It will eventually fail if it is used that way. Stranded core wire should be used for patch cables. These days the price for (pre-made) patch cables is low enough from somewhere like Monoprice (www.monoprice.com) that it's almost not worth it to make them from scratch anymore. The quality of the pre-made cables is better too especially if you buy Cat6 cables. (They are a bit tougher/stiffer due to having a plastic divider in the middle to separate the pairs.)
TED
P.S. Apologies to those of you who already knew this! As I said before I don't intend any insult!
JHinkle wrote:Ya - now that I'm an old fart and retired - I have time to play and do things my way.Joe
I love it! 😆
