My idea was two different transformers 3FS-312 and 3FD-312.
Use 3FS if you are 110 and 3FD if you are 220. No jumps - just plug in the correct one.
Joe
That makes a coop of the board a bit more complicated when you need to specify options like that. Of course the one running the coop could have multiple BOMs, but then you loose the quantity discount for the less popular transformer. Is the selectable transformer that much more expensive, or bigger than either of the two individual ones??
JHinkle wrote:I wanted to detect a little before ZC on both halfs of the power cycle and the led drop from both leds should provide that better than using an input. This "just before" ZC event will provide time to disable drives to the SSRs so that at true ZC - the triacs will turn off.
You could probably just use the leading edge instead of the trailing edge of the ZC signal and then add a little delay if you wanted "just before" detection.
don
I agree - my communication skills go down the tube the older I get.
I am using the trailing edge for clean-up and leading edge for dimming.
That makes a coop of the board a bit more complicated when you need to specify options like that. Of course the one running the coop could have multiple BOMs, but then you loose the quantity discount for the less popular transformer. Is the selectable transformer that much more expensive, or bigger than either of the two individual ones??
As someone living in a 230V country, I feel uncomfortable with the idea that people in 110V countries would be paying more for their parts to make things slightly cheaper for me. But grateful that you would consider it.
I suggest that the transformer could be made optional in the BOM. In a coop, 110V people would get the full BOM, 230V people would get the BOM excluding the transformer. They could then source the correct transformers themselves, either as individual parts from e.g. Mouser, or by having their own little transformer coop to buy transformers in bulk. The extra cost of the transformers would be offset by the lower shipping cost of the rest of the BOM. (Shipping from the USA to NZ can be a big percentage of a parts purchase, and the transformer is a big part of the BOM weight and volume).
NB: In case it's significant to the design, Australia is a 240V country.
