New Controller desi...
 
Notifications
Clear all

New Controller design

131 Posts
26 Users
0 Reactions
44.7 K Views
Posts: 3650
Topic starter
(@jhinkle)
Famed Member
Joined: 15 years ago

Great comments n1ist - thanks.

Joe


Reply
Posts: 183
(@buckanear)
Estimable Member
Joined: 15 years ago
JHinkle wrote:I looked hard for a part like the 541 - could not find a number part. I have replaced the 244 - makes the design much cleaner besides increasing drive from 6 to 8ma. Pic shows 74LS541 - Fixed label - should be 74HCT541.

Moved track as suggested.
Moved C2
Added bypass caps
Added mounting holes
AC Neutral was on top so I don't understand comment.
I don't use auto-route - all done by hand. 244 made it difficult to route. Replaced 244 with 451 - much cleaner.

On track size - driving all SSRs at the same time will require 120 ma.

Use the wire size calc:

http://circuitcalculator.com/wordpress/category/calculators/electrical-engineering/

200 ma on 1 oz cooper - trace 6 in long - ambient temp of 50f - want no more than 1f increase in temp - gives a trace width of .019. I am not taking inductance into account.

19 mils is for internal layers on the laminate and assuming FR4. For outer layers the track with for your conditions is far less, 8 mils.

My track for the SSR power and ground is .050 in width - that seems a nice design margin - what am I missing - maybe the picture was mis-leading.

Track width to the cpu - power and gnd is .032.

Thanks for the comments - multiple eyes are better than one.

Joe

For the most part your track width are very conservative and that is fine. The ambient temperature rise of 1 degree F even adds a more conservative approach. Unless the board is operating in extreme high temperatures, 10 degrees F rise I would think is acceptable for FR4 laminates. As for track inductance, that can just about be forgotten dealing with the rather low frequencies dealt with. Now if one were switching at say 200MHz or so then track inductance may very well be an issue. Skin depth becomes an issue then as well as the track adding stray capacitance and acting as a transmission line.

Wider tracks do help in heat sinking parts to some degree.

Outside the previous comments to correct the layout is not bad. Looks like you used Eagle.

just my thoughts
james


Reply
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago

Any thoughts on making this compatible to 220/240v and 50Hz operation? This would open it up to more international use. It appears you have a dual-secondary transformer so with a jumper you could put them in parallel instead of series. The Renards currently have code for 50/60Hz detection to get the ZC sync timing correct.


Reply
Posts: 3650
Topic starter
(@jhinkle)
Famed Member
Joined: 15 years ago

Brian:

The secondaries are in parallel. It is the same transformer used on the Renards.

What do you do to a Renard to operate it at 230?

50/60 hz ZC detection is easy - that just software.

Joe


Reply
Posts: 987
(@wirewrap)
Noble Member
Joined: 18 years ago
JHinkle wrote:Brian:

The secondaries are in parallel. It is the same transformer used on the Renards.

What do you do to a Renard to operate it at 230?

50/60 hz ZC detection is easy - that just software.

Joe

To operate at 110/220, you need dual 110v primaries in the transformer. Then for 220 you have the primaries in series, while for 110 they are in parallel.

🙂


Reply
Page 10 / 27
Share: