LV 8-Channel Driver...
 
Notifications
Clear all

LV 8-Channel Driver Board

4 Posts
2 Users
0 Reactions
2,453 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
[#3685]

Lately I've become somewhat unhappy with the sprinkler controls here, so I've decided to try and piggy-back a new controller on top of some of the other projects that I've been working on.

Since the PIC that I've been using (PIC24HJ12GP202) doesn't have enough pins to nicely drive both a graphic LCD display and eight triacs, I designed a little expander board. The TO92 parts can be either Z0103 triacs or NPN transistors, so the board can be used for either low-voltage AC or DC. There are no optos on the board, so it is not good for AC line voltages. The 16-pin chip is a 595, and the 14-pin chip is a 74HCT125 (since the PIC has TTL output levels). The pinout on the RJ45 connector is the same as the coop 595 boards, except that the serial output from the 595 is brought out to pin 6. The board is 1.75x2.25", and the holes are the same as those on the Radio Shack prototype board that I've mentioned in another post.

I'm not sure if I'm going to go through with this board or just use point-to-point wiring, but I thought that I'd throw it up for comments.

ssr 8ch lv

3 Replies
BuzzKill
Posts: 577
(@buzzkill)
Honorable Member
Joined: 19 years ago

What will drive it? Are you thinking you would use vixen for your sprinkler control?


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago

The PIC on that PIC24 project that I mentioned in another thread. There will be an interface to a 128x64 LCD and to a quadrature encoder used for input. In the end it will be an expensive replacement for the automatic lawn sprinkler controllers that you can get at home depot.


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago

This is now on indefinite hold. I discovered that I had some PCBs for a PIC12F629-based 4-channel dimming controller (unused because of some design flaws that would affect 110VAC use). After some minor firmware changes (to reduce the chances of the recurrence of a $1000+ water bill from when I was last on vacation) these will work perfectly for this application


Reply
Share: