My suggestion is to look at WLED. With this you can get the best of both as you can do individual control of strings. You can sync strings or groups o...
You can do the same thing loading up WLED and configuring the E1.31 listener. I have tried it, and it does work. But it was on an 8266 and was a smidg...
Do you mean like with WLED? I have strings here. You can do E1.31 or MQTT (probably not very fast refresh rate). What are you wanting to try? I hav...
There is a good series on Youtube about permanent LED outdoor lighting. Hooking up ESP32 or ESP8266 devices to stings of LED's is way more straight-fo...
RichieNorthcott wrote:That should work - In the squeeze for time I just simply abandoned the effort in order to get the rest of the elements workin...
Mix 75 toroid ring. Make at least 9 wraps through the ring and connect to the transmitter. You can get the rings on Amazon. Or palomar engineering.
It could be, as pointed out, that I just needed to close Vixen and re-open. Fog of war. I also had to do that to get the audio out the proper audio ou...
Plain 'ol Enttec Open DMX adapter. I should have just purchased the Pro. More learning.
RichieNorthcott wrote:You can patch a node to both a real controller and the 'debug' controller simultaneously, make sure to select the 'use all avail...
1pet2_9 wrote:I'm an xlights guy, but I feel your DMX pain. So much development that needs to be done, but isn't. Do you still need all your Renards...
Since you are already at SMB/prosumer level gear, look at TPLink Omada. They have a very reasonably priced outdoor rated AP. EAP225-Outdoor.
rstehle wrote:It is safe to use outdoors, but the insulation will begin to deteriorate after a few seasons of use. Which... makes it unsafe to use o...
Yup. Just solder directly and use heat shrink with the internal glue (marine) to seal the connection.
Go with lithium iron phosphate. Way higher power density, can discharge over 80% with no damage, and since you specifically say these have to be batte...
