I have designed a new version of the ESPixelPop by Bill Porter. My version is the ESPixelPop32-AIO (ESPixelPop ESP32 All-In-One). I am new to PCB design, so its a bit sloppy. I may be able to reduce the size, and remove a few components, but it should work. This is V1, so I know it will change over time.
Key Design Ideas:
1. Incorporate the ESP32S, a Dual-CPU, 3 UART, Bluetooth enabled, Wifi hybrid version of the ESP-01. It also has additional 16MB of external Flash, optional. With the addition Bluetooth and external flash, this could open a whole new realm of display ideas.
2. Incorporate a built in USB-to-UART chip, so no more FTDI required. Simply install the drivers for the CP2102 Chip, plug in your USB Micro B cable, and upload the ESPixelStick firmware from ForkinEye and away you go!
3. Incorporated 2 data wire outputs, to explore the use of 8 universes, 4 per UART.
4. Incorporated LED indicators, for Power, programming, and Data Wires, to better facilitate troubleshooting, and other issues.
5. Explore the Bluetooth functionality, to allow for testing or updating the firmware without removing the ESPixelPop from the show, container, or power.
What I need:
1. Someone (or some people) who is/are familiar with ESP32 and ForkinEye software.
2. To program Forkineye's software to reflect the new changes, if any, and if possible to include bluetooth capabilities.
3. Someone who can look over my PCB and make design suggestions.
4. People to test! Once I get the prototype board, I will be testing for functionality. After that, I will be selling test boards @ cost. So far, they run about $4 assembled, plus the ESP32 module, so around $8 -$10 depending on vendor sourcing. I expect with bulk buys, they could get as low as $6 - $8 assembled.
They are a little more costly than the original ESPixelPop by Bill Porter, but not by much, because of the use of SMD components. I was able to cut the hardware costs almost in half because of that, and the cost savings were spent on the ESP32 module and built in FTDI. So the idea was to get better performance, more features, and an AIO solution for around the same price as a single ESPixelPop.
They are also larger, being 49.5mm x 32.64mm (1.95in x 1.29in), but still super compact and small!
Anyone interested, please let me know. As of this moment, I have ordered all the SMD parts, 30 boards, and 5 modules. The reason I ordered so many boards, is that OSHPark quoted $14 for 3, and I could get 30 for the same price. Soooooo, no brainer. Each board will be hand soldered, until such a time that R&D is done, and if it makes it to that stage I will be having the SMD components assembled at the fabricator.
Happy Holidays, thanks for looking, and your feedback would be appreciated!
P.S. Should this project be a success, and since I am asking for community help, these will be community items, shared with the community, and sold @ cost when the project is complete.
Order from OSHPark if you are impatient!


