I've used the Winamp plugin before, I wasn't extremely happy with the result but I didn't spend a whole lot of time configuring it so I'm sure I could get it better. It was still cool to see the lights going without a sequence.
And then there is, for the DMX crowd, the VBlink Winamp plugin and DMXControl Combination. With a bit of tuning of Winamp and DMX Control's sound analyzer sound-to-light function...
how in depth does that plugin go for DMX and how many channels does it support?
CrazyG wrote:And then there is, for the DMX crowd, the VBlink Winamp plugin and DMXControl Combination. With a bit of tuning of Winamp and DMX Control's sound analyzer sound-to-light function...
Now that I will soon have a programmer DMX starts to become an option for me aswell, I've heard the DMX software is a bit better.
griffixdc wrote:how in depth does that plugin go for DMX and how many channels does it support?
As I recall when I played with it, Vblink uses the same data stream that drives winamp's spectrum analyzer. In DMXControl the sound analyzer breaks out the audio spectrum to 24 frequency bands each of which can be assigned to any number of DMX channels 1 through 1024. The sound to light part of DMXControl sends brightness level (0-255) to the assigned channels based on amplitude of the frequency band or you can set it to just do on/off at a selectable preset brightness.
It works, but the processing overhead contributes delay so someone watching intently will definitely notice. On another board, a long time ago, some folks discussing this deemed it suitable for casual "party lights" type usage but no substitute for actual sequenced programs.
Anyway that is what I can remember about it when I tried it.
Another winamp plugin possibility to look into is SoundGraffiti Dimmer if it supports the DMX dongle you happen to use and you don't mind parting with the cash to buy it ($100 I think).
