FPP PB16 Pixel Cont...
 
Notifications
Clear all

FPP PB16 Pixel Controller

630 Posts
62 Users
6 Reactions
389.8 K Views
ukewarrior
Posts: 4674
(@ukewarrior)
Illustrious Member
Joined: 18 years ago

Exactly right.
If you look you will always see a status LED to be paired with a dropping resistor to bring down the current so the led doesn't burn out.
These can be omitted in almost all cases or replaced with a led that has a lower lumen rating.
This is true of almost all boards you encounter.

Glycerine wrote:Should just be able to remove it from the board. Or not solder it on in the first place if building from scratch. Or you could look for some with a smaller light output if they're too bright for you.

Reply
Posts: 87
(@rjlangley)
Trusted Member
Joined: 13 years ago

Wow! Very cool. Thank you for your efforts into this.


Reply
Posts: 128
(@sctwohig)
Estimable Member
Joined: 10 years ago

My boards arrived today. Can't wait to get ahold of all the components.
Anyone happen to build the BOMS from Arrow.com that they would be willing to share.

Thanks,
Shawn


Reply
rayhjr
Posts: 972
(@rayhjr)
Noble Member
Joined: 12 years ago
sctwohig wrote:My boards arrived today. Can't wait to get ahold of all the components.
Anyone happen to build the BOMS from Arrow.com that they would be willing to share.

Thanks,
Shawn

I did not have much luck finding what I needed with Arrow. If you have 2 month to wait until parts arrive, you can find most of it on Alli Express and save alot of money. I did order 1 BOM from Digikey ( minus what I already had) and it arrived within the week minus some resistor arrays that were backordered and came in a month or so later. This was also back in February or late January when things were failing apart overseas. Good luck!

Sent from my SM-A505U using Tapatalk


Reply
Posts: 39
(@jleiwig)
Trusted Member
Joined: 17 years ago

I had to source from Arrow, Tayda, and Digikey. Once it comes in and I can verify I will be glad to share.


Reply
Page 45 / 126
Share: