For all of you that have been following this and like me after 5-6 hand wired tubes is getting lazy.. There is now an interest thread to see if it's viable to do a co-op this season.
FAST / LEDancer Interest Thread
Cory:
I've reread this thread a couple of times and I don't think I can find an answer to this question:
I don't think I want tubes that are as long as you originally designed ... something more along 12-18 inches would work better in my display ... can I put a header board and two or three LED boards together and it will still work?
Thanks.
\dmc
Yes That was the idea behind the modular design. There are provisions in the firmware to set the number of LED's before repeating.. So if you wanted 8 tubes 18" you could get 8 header boards and 3 sets of the segment LED PCB's
chelmuth wrote:Yes That was the idea behind the modular design. There are provisions in the firmware to set the number of LED's before repeating.. So if you wanted 8 tubes 18" you could get 8 header boards and 3 sets of the segment LED PCB's
Thanks. I thought I'd read that somewhere but couldn't find the original post.
\dmc
How does all this compare with doing a similar thing using one of the RGB pixel strings? I think that either one of the controller boards pictured above could (with new firmware) create the same effects using one of the pixel strings. I haven't been following the threads in the DMX section discussing the various controllers nor am I familiar with all of the different types of pixel strings available, but I think that it would not be to hard to create the effects that people here are desiring with just a simple controller similar to the FAST or the LEDancer controller. The controller doesn't need to be as fancy as those over the DMX section.
Just a thought, as I don't really have a grasp on the $ numbers for the pixel strings.
It has been a lot of fun working on the LEDancer controller and LED module, but I'm not sure this is the best approach, at least not until I know the numbers.
