Finally Affortable ...
 
Notifications
Clear all

Finally Affortable Snowfall Tubes (FAST)

448 Posts
68 Users
0 Reactions
262.9 K Views
Posts: 2168
(@djulien)
Noble Member
Joined: 19 years ago
P. Short wrote:How does all this compare with doing a similar thing using one of the RGB pixel strings?

I think the only difference would be that you would not need the chipiplexing transistors (unless maybe the signal was being driven a long distance), and the output logic in the firmware would be different.

For example, a similar type of controller can drive a string of LDP6803 pixels, and from what I've heard those are vaguely similar to WS2801 pixels (SPI interface). Here is some sample code I was playing with a while back - sorry for the mess (it just uses bit-banging rather than a PIC with an SPI interface).

EDIT: For larger pixels/strings, this can also be used to drive AC SSRs if you omit the resistor in series with the MOC3023 and maybe adjust the chipiplexing resistors to reduce the current flowing thru the input side of the optos.

don


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

That solution would be quite a bit more "spendy" than this design which is designed to be ultra cost sensative (and mono-colored).


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago
jrock64 wrote:I still like my coffee/candle warmer and embossing gun.

Very easy to control which parts get heated.

Joel

Ah but a griddle does not blow the parts all around requiring intervention with the needle-nose. I've never seen parts fly out of position with the griddle!!!


Reply
Posts: 344
(@sloanhaus)
Honorable Member
Joined: 19 years ago

New to this thread but am wanting to do some of these at my parents house this christmas. Do these have to be connected to a computer, or are they basically set to do what you want. I really would like to be able to daisy chain them into a tree and not have them connected to a computer.

Thanks

Sloanhaus


Reply
chelmuth
Posts: 1077
Topic starter
(@chelmuth)
Noble Member
Joined: 16 years ago

Just apply 5v and they run.. no need for a computer.. they each draw probably about 30ma.. so a 1amp power supply would do about 30.. There is currently a group buy in progress for these that will be running for about the next 2 weeks..

Here.
http://doityourselfchristmas.com/forums/showthread.php?16456-FAST-Ren48LSD-Ren4Flood-DIYC-Flood-Offsite-Group-Buy


Reply
Page 32 / 90
Share: