FAST troubleshootin...
 
Notifications
Clear all

FAST troubleshooting

38 Posts
12 Users
0 Reactions
10.9 K Views
Posts: 859
(@smartalec)
Prominent Member
Joined: 17 years ago

now that compiled fine, maybe it was cause i was using the project wizard.
thanks heaps erik


Reply
erm213
Posts: 479
(@erm213)
Honorable Member
Joined: 16 years ago
smartalec wrote:now that compiled fine, maybe it was cause i was using the project wizard.
thanks heaps erik

Glad to hear it! Enjoy those blinky tubes.

Erik


Reply
Posts: 859
(@smartalec)
Prominent Member
Joined: 17 years ago

ok i programmed it an changed the line 327 to 28 = 4 boards
now they seem to chase the once down (on power up), then only the last led will keep flashing only no others..
is there another line im supposed to change? or any wiring on the last board?
thanks alec.


Reply
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

I'm not sure what else you changed but to set the fall to 28.. the code should look like this below. I just tested and verified this works.


 movwf Dim100                    ;Move W Register to Dim100 (Brightest LED)
 movlw d'56'       
 movwf full                      ;Move W Register to full
 incf  full, 1                   ;Was easier than explaining add 1 to LED count.
 movlw d'28'
 movwf fall_count                ;######## Set number of LEDs attached to controller ie. 3 segments = 21

e


Reply
Posts: 859
(@smartalec)
Prominent Member
Joined: 17 years ago

silly me, this time i was using old firmware, got the latest firmware an it works like a dream


Reply
Posts: 231
(@jmksparks)
Reputable Member
Joined: 18 years ago

First of let me say how great these FASTs are, I am up to #10 of 30 tubes I bought in construction and I must say I am having a blast. This is the first time I have ever messed around with code and so far so good, the only thing that made me do this was because the radomness was well not to radom. Played around alot with parrameters that we were told could change but I was still not happy. So looked around and found FALL RATE 40 not marked as something we should touch, what the heck try it! YES, slowed them down a treat. So I got to thinking why not put a diff fall rate in each PIC, I.E. 50-51-52 ETC. Well it works like a charm for me radomness everywhere ! But I suppose you guys all ready know this right, just thinking I may have found this before anyone else.


Reply
chelmuth
Posts: 1077
(@chelmuth)
Noble Member
Joined: 16 years ago

It wasn't something I was sure people wanted to play with but it was commented that you could change it and it would either speed or slow the fall.. glad you found a setting that worked for you.


Reply
Posts: 231
(@jmksparks)
Reputable Member
Joined: 18 years ago

Yes thank you, there is also a fine balance between slowing and to slow. To slow producing an enhanced jitter action does not look good unless like me I have to put up with a distance between show and public.


Reply
Page 4 / 4
Share: