It seems like setups could be simplified significantly if you get LED strings which can already fade and do patterns.
Then you can unscrew the box, chop out the chip, attach your own PWM controller to the outputs and then your done since all the circuitry for handling the mains power is already there for you. 😀
I'm just starting my collection this year, and I've got experience with microcontrollers (especially AVRs).
So I've bought 5x 10 meters of LED christmas lights which already do patterns off ebay and they are in the mail at the moment.
I've been skimming this forum and the wiki but I havent seen anyone mention doing this before?
Some of the controllers that come with typical strings are pretty dodgy to start with. They usually make them only just good enough to work with the string to keep costs down. Interfacing to them could be difficult and potentially dangerous IMO.
Cheater,
The best option is to remove the controller (MFC) completely. I have seen a number of the MFCs, and the workmanship is fairly poor.
Trying to interface into the IC controller would be problematic, of the 6 builtin programs, it would be hard to know what one the unit will start in, and who to 'step' them thru to your selected sequence. I'd be more incline to watch the programs and get a feel for how you could replicate some of them in vixen (with better control).
The overall design is the same for 240 and 24 V versions. the Board is designed a single chip controller, and 2 to 5 SCRs to switch the load.
AC is rectified by a full wave bridge (normally 4 diodes), a Zener diode is used to provide a 5 Volt rail for the IC, and a sample of the AC is used by the IC to calculate ZC.
The Common is generally the positive rail (for 24 VAC, this will be unfiltered DC at over 30 V DC), and the SCRs are Sink switching to the negative rail.
Removing the controller, you will end up with a string that can be controlled by a AC SSR (single channel) or DC SSR (multiple channels).
There will be a need to measure and adjust current flows thru the LEDs. I have generally found that the LEDs are being drive at or over 20mA.
There were a lot of discussions on the BIG W string thread on ways to normalise the current on those strings, the concept is the same for MFC strings. Most will just need a low ohm value resistor added to the negative line to limit current flow thru the LEDs.
hope that helps.
wjohn wrote:The best option is to remove the controller (MFC) completely.
Thats my intention. 🙂
Ditch the chip which has the preset patterns but keep the support electronics.
While the circuitry may be dodgy, I'm kinda lazy and it saves quite a bit of work. 😉
Hong Kong quality should do the trick....just.
I have to wait for them to arrive but that information should help me a lot. 🙂
If the IC runs on 5v then I'm thinking of simply using a optoisolator or similar to trigger the lights.
Less parts and simpler that way.
Part of the problem John & I are alluding to is you'll probably waste more time and money than it's worth trying to part of the original controllers.
If you're just keeping the switching section, then that's only four $0.50 TRIACs. You'd still need to add opto's etc.
