I am new to all this, but I just have tons of ideas. Now that I have a LITTLE bit better grasp on things, I have the following question:
Why have Bill Porter and the other guys that made PixelPops and PixelSticks not made a simple, multiple output version yet? The ESP-12 module should have 8 useable GPIO pins, each capable of 4 universes, all over WIFI! In fact, I would think the programming is a matter of just adding a few more "copy paste" lines to compensate for the added GPIO pins, and then adding the additional traces, triacs, transistors, and board space.
Any reasons why it wouldn`t work, or why it is not practical? I am no electrical engineer, but I am tempted to give it a shot myself. I have used DesignSpark in college, so maybe??
If it is something worth pursuing, any design ideas would be great!
it uses the UART for the pixel output, if you use other GPIO, WIFI can't function at the same time and cause the ESP to reboot(watchdog).
pakeonoahu wrote:it uses the UART for the pixel output, if you use other GPIO, WIFI can't function at the same time and cause the ESP to reboot(watchdog).
Well, that answers that.... And here I thought it was controlled by the GPIO.
I guess when I get my ESP chips in, I will try a few different things. There has to be a workaround, I would think. Maybe MicroPython is the workaround???
There are tight timing constraints on the lighting output. If you don't meet the timing requirements, your light string won't work properly when the CPU gets busy (e.g. dealing with a WiFi message).
Changing to MicroPython (or any other language) may reduce the problem, but probably won't eliminate it. Interpreted languages like Python are worse than compiled languages like C. You *might* be able to eliminate it entirely with some hand-crafted timer-interrupt-driven code written in C or similar, or in assembler (does anyone still do assembler nowadays?).
Given that an ESP costs under $2 and a 5m pixel-strip costs $20, you aren't saving much by putting 4 strips onto one ESP.
If you really want to control 4 strips from one ESP, you can connect the strips serially, running a data wire from the end of the one strip to the beginning of the next.
frankv wrote:If you really want to control 4 strips from one ESP, you can connect the strips serially, running a data wire from the end of the one strip to the beginning of the next.
Many thoughts crossed my mind when posting the question. I built each of my ESPixel Pops for around $4, so I guess when you really think about it, 32 pixel pops would give you 128 universes, only power needed, wirelessly, all for $128 and they are so tiny! So, I guess its moot.
However, i have a greater understanding than I did before, and that is always good!
