Another Ren64 Appro...
 
Notifications
Clear all

Another Ren64 Approach

28 Posts
10 Users
0 Reactions
10.5 K Views
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

That looks nice Phil! Could you put another mounting hole on the other side of the transformer? That would probably ensure that the controller would stay still. A mounting plate of acrylic or plastic cutting board may be needed if it can't reach common mounting holes.


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
Jrd wrote:That looks nice Phil! Could you put another mounting hole on the other side of the transformer? That would probably ensure that the controller would stay still. A mounting plate of acrylic or plastic cutting board may be needed if it can't reach common mounting holes.

Good point.


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago

Ungestating this for a bit (if that's a word) after getting a bit bored at B&N. This version of the board is just a smidge under 10cm x 10 cm (~4" x 4"), intended for a CG-500 enclosure. The hardest part of this re-design is trying to come up with a way of arranging the components so that there is even a small chance of removing the CAT5 cables once they are plugged in. Anyway, time to place an order with elecrow.


Reply
Posts: 4092
(@skunberg)
Famed Member
Joined: 18 years ago

I love it when you get bored.


Reply
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago

The only problem is that I mostly get bored while waiting for PCBs or parts to arrive in the mail. And by the time they do arrive, my focus has shifted to something else, so I have a lot of un-built boards that have accumulated over the years.


Reply
Page 4 / 6
Share: