Anachronism...
 
Notifications
Clear all

Anachronism...

3 Posts
2 Users
0 Reactions
2,145 Views
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago
[#30575]

Here is a little something that I worked on while hanging out at a birthday party that my son attended today..

It's a combined Ren-T and Ren-C that fits in a polycase.com wall-wart enclosure. The board shown is from a project that I've set aside for the moment, but could be easily modified for this purpose by changing a few traces. The PIC is a PIC12F1840 enhanced mid-range part (a cousin of the PIC16F1825). This board has a transformer for powering the on-board parts and generating the zero-crossing signal, an H11AA1, and an RS485 driver/receiver. Obviously this board doesn't have the status LEDs nor the ICSP connector from the original Ren-C design.

The Ren-C/Ren-T combination is a dead horse, so this isn't going anywhere. But modifying the Ren-C firmware for the smaller (but faster) part was an amusing way to spend a few hours.

100 0672

2 Replies
Posts: 6728
Topic starter
(@p-short)
Illustrious Member
Joined: 20 years ago

That transformer was only intended for powering the on-board parts, but the next larger Tamura transformer would fit in the same holes, and could be used to power the Grinch board as well. That transformer is 1/4" taller, and would need the next-tallest wall-wart enclosure from polycase. That, along with an appropriate regulator and filter capacitor...could almost work.


Reply
Posts: 3277
 Jrd
(@jrd)
Famed Member
Joined: 19 years ago

...I didn't even know wall wart enclosures could be bought before... Very interesting...


Reply
Share: