Here's a 64-channel renard-based board that I've designed that should come out a bit cheaper than the current design, at the cost of giving up the status LEDs. It has an on-board transformer, so it should be fairly easy to deploy in the field.
The PCB here is about 1/2 the area of the Renard64 PCB (16 sq-in vs 32.5 sq-in), so it should be less expensive. My goal here was to keep the board dimensions under 5cm x 20cm, so prototyping expenses could be kept down. The one thing that does bother me about this PCB design is the lack of mounting holes on this version of the board. Adding mounting holes would take the board length up above 20 cm, which would push the board size up into the next price category at the elecrow pcb fabrication house.
The basic concept is to use a single PIC (PIC12F1840 in this incarnation) and eight HC4094 shift register chips. This is similar to how the Ren-C works. The HC4094 is similarly to the '595 chip with a few minor differences. I chose this chip because it was easier to route the traces to the connectors than the '595 chip.
looks good! Another great option, and low cost is always welcome!
mounting holes was the 1st thing i noticed as you mentioned, is the 5CM fixed? Can you add a 5-10 mm on each side of the RJ45s and add the mounting holes there (to match to some CG case possibly)?
I am far from a designer, but is U1 the PIC12F1840 and U2 a 485 transceiver?
Also it looks like it on the far right, but a power LED for the board?
imbluenote wrote:looks good! Another great option, and low cost is always welcome!mounting holes was the 1st thing i noticed as you mentioned, is the 5CM fixed? Can you add a 5-10 mm on each side of the RJ45s and add the mounting holes there (to match to some CG case possibly)?
I don't have a CG case, but it appears that the mounting holes are on 1.5" centers. I'd be more inclined to make the board about 0.3" longer and place the holes between some of the RJ45 connectors.
I am far from a designer, but is U1 the PIC12F1840 and U2 a 485 transceiver?
Yes.
Also it looks like it on the far right, but a power LED for the board?
Yes.
Just a heads up elecrow is about $50 for 10 copies of that sized board 5 x 20. Close to $60 if you want it DHL, Normaly they are produced and shipped. in 4-7days.
I like it nice simple layout.
This may be a stupid question, but are the outputs dimmable?

