16_Expansion_SMD
 
Notifications
Clear all

16_Expansion_SMD

6 Posts
3 Users
0 Reactions
3,336 Views
Posts: 115
Topic starter
(@strawberry)
Estimable Member
Joined: 11 years ago
[#55763]

I've assembled a couple "16_Expansion_SMD" boards from Scott Hanson's design when testing using the BBB_16_Expansion I noticed the lights flickering in test mode. it resembles a loose/no ground for the pixel data. I assembled 2 boards which have the same characteristics and have also tested on a F16V3 with the same flicker.
Any Ideas?

Comparing the through hole VS smd design the only difference is R3 is 330 ohm.


5 Replies
Posts: 115
Topic starter
(@strawberry)
Estimable Member
Joined: 11 years ago

Pic

Sent from my SM-G960U using Tapatalk


Reply
Posts: 6
(@mrpburke)
Active Member
Joined: 5 years ago
Strawberry wrote:Pic

Sent from my SM-G960U using Tapatalk

The schematic shows R3 as 120ohm but I dont think that would affect data output since it's just for the 5v led. Maybe a bad solder joint somewhere?


Reply
Posts: 115
Topic starter
(@strawberry)
Estimable Member
Joined: 11 years ago

I reflow every solder joint on both boards.
Ports 17-20 work fine. The rest of the ports have a flicker, on both boards.

Sent from my SM-G960U using Tapatalk


Reply
Posts: 87
(@scooter-seh)
Trusted Member
Joined: 12 years ago

I have never built one, maybe I will order some to verify everything is correct.


Reply
Page 1 / 2
Share: