WakeFan
WakeFan
@wakefan
Prominent Member
Joined: Jun 2, 2007
Topics: 73 / Replies: 660
Topic
3 years ago
Replies: 5
Views: 1063
Topic
3 years ago
Replies: 1
Views: 574
Reply
RE: Renard as hook up help!!!!

Also open device manager and look at the properties for com port 5... make sure no device conflicts and see if there are any settings that could be ca...

4 years ago
Forum
Reply
RE: Renard as hook up help!!!!

Have you checked the cable? Change voltmeter to ohms and check ends to be sure they are correct and connecting. If its a homemade cable, someone may...

4 years ago
Forum
Reply
RE: Renard as hook up help!!!!

Both power plugs are plugged in and power light is lit on board? Hey... I've done it before Sent from my SM-G781V using Tapatalk

4 years ago
Forum
Reply
RE: Renard as hook up help!!!!

When you say light up... what are you looking at? The LEDs on the board will only light up when the corresponding channels come on.. Channels 2,5,...

4 years ago
Forum
Reply
RE: Renard as hook up help!!!!

Phil mentioned resetting the IC chips. All the chips are in sockets and can be removed..... with the power disconnected. If you do that, be very c...

4 years ago
Forum
Reply
RE: Renard as hook up help!!!!

Probably not it since you confirmed it earlier. It's where you posted pics of both device manager and Vixen. That same screen is where you can chan...

4 years ago
Forum
Reply
RE: Renard as hook up help!!!!

If it worked for a few minutes, check your com port settings again. Sometimes device manager drops the com port and assigns it to another one. Sent ...

4 years ago
Forum
Reply
RE: Vixen 2 conversion to vixen 3

It should bring up a window that says Vixen 2 to Vixen converter. Under the channel maps on the left side of that window should be a button to create...

4 years ago
Reply
RE: Trying to Get an Old Renard SS8 Running - Power But No Blinky Flashy...

They should respond for channels 2,5,6,7,8 as they are turned on and off. I would try COM port settings in your software. Serial adapters seem to ju...

4 years ago
Forum
Reply
RE: Vixen 2 conversion to vixen 3

I added the google drive links to the Vixen Jira page

5 years ago
Topic
5 years ago
Replies: 15
Views: 4009
Reply
RE: Vixen 2 conversion to vixen 3

I know this goes back a bit... I opened a ticket but was unable to attach the files. it gave me a failed to load error. I think the files are too la...

5 years ago
Topic
Replies: 2
Views: 881
Page 2 / 49