Thanks, I just ordered one. I will give a try and see if I can find the right size.
bud29 wrote:The newer pixels have a different timing something or other(can't remember the techy name) but updating the firmware should do it for you ...
Its a E682, it sure could be I will see if I can get new firmware
I love my E682's for megatree operation. I run falcons for my other items, but I have a single e682 just for running the mega tree. I like that I don'...
I have 2 F16 w/ 4 remote boards and 2 682's and a few T24's. I like the F16 becuase you can run the remote boards to long runs from the main controll...
For a mega tree I just find the strips to costly and like others said normally a single node can be repaired and waterproofed way easier. I had a stri...
Someone linked these in the past from ebay, I marked it. I'm not sure if this works or not but they do say 33 ohm.
Ruppro wrote:Don't have your sequencing PC on the same network as the controllers, or use dummy IPs on the sequencing PC for the controllers, that is ...
I had a problem with my WiFi signal at the location were the Pi was, so I added a WiFi repeater to the mix. This worked for the access to the WLan (19...
