Activity
 
Notifications
Clear all
timon
timon
@timon
Noble Member
Joined: Dec 30, 2010
Topics: 165 / Replies: 1984
Reply
RE: Testing the Ball and the drone's "point of interest"

plasmadrive wrote:This one is a dodecahedron and the exterior is self supporting.. however there is a platform inside to hold the controls and to supp...

11 years ago
Forum
Reply
RE: Testing the Ball and the drone's "point of interest"

Nice job. Think geodesic dome should get one started. How smooth a sphere you want depends on how many equilateral triangles you want to use. Should ...

11 years ago
Forum
Reply
RE: CG-1500 3" Fan Cover

It's better to have the fan suck the air out of the case rather than push it in and don't forget inlets for the air to enter.

11 years ago
Reply
RE: HDPE Arch Bases

How did your connect the waterproof cable that goes through the base to the strips so you can remove the strips and tube from the base?

11 years ago
Reply
RE: Christmas Light Fight starts tonight on ABC...

First things first. Matt, great job on the show. The sequencing to the music was great as was the overall construction. You've done a great job of mou...

12 years ago
Forum
Reply
RE: Christmas Light Fight starts tonight on ABC...

Wow, this years show was much better than last year and we have one more week to go. I loved the piano and the moving head lights. The pixel matrics ...

12 years ago
Forum
Reply
RE: Need help making WS2821A work with DMX

David been busy working on the code for the new FPD and F16 so I don't think he's had time to play with it yet.

12 years ago
Forum
DMX
Reply
RE: Any Radio Tower Experts out there?

The bottom line is the wind rating of the tower. It should have a rating on how many sqft of antenna area it can handle for a given configuration. If ...

12 years ago
Forum
Reply
RE: New North Pole similar to Coro-canes and Xenialight's Coro columns

Finally did find some information. Basically you still cut circles but you need to adjust the center hole and outside diameters since they get smaller...

12 years ago
Reply
RE: New North Pole similar to Coro-canes and Xenialight's Coro columns

Actually it won't work cutting circles and round holes in the center. You need to cut them the way and auger is made then they will spin up very clean...

12 years ago
Reply
RE: VAST all in one V-FMT212R FM Transmitter with RDS

I'm still working on a board that allows using the FM02 without the display board. Initially it will be for use with the new FPD or F16 with the Pi pl...

13 years ago
Forum
Reply
RE: Working on a new pixel controller.

FYI, I found a case so SSC could be built with buck converters. The issue has been getting rid of the heat which you cannot do with a PCV pipe enclosu...

13 years ago
Reply
RE: Need help making WS2821A work with DMX

The way I would use them is to run RS485 from the controller unless its close then convert to TTL you should be able to use the converters you would u...

13 years ago
Forum
DMX
Reply
RE: Backlit printed coro?

If you cannot fine a local place that prints on Coro Build A Sign has a 30% off sale till the end of the month. You can find the information in a thre...

13 years ago
Reply
RE: BuildASign.com 30% off sale

Your welcome. I need to finalize my FM frequency for this year so I can order my Tune to sign.

13 years ago
Page 2 / 144
Share: