Yes, 20% seems about right. It's nice to be able to actually see the house. Thankfully the Falcon Controller made it easy to change this. Mind yo...
pmiller wrote:You might want to consider using a step drill. Forstner bit might chip. Sent from my SM-T710 using Tapatalk I have a step bit so I'll...
After some experimentation I have determined I'm going to use: 2" wide strips of 1/16" white acrylic sheet - drill 12mm holes drilled with a forstner ...
Okay so it looks like I just need thinner material like the premade strips which I would then attach to a more sturdy material. I considered aluminiu...
gassy wrote:What's your end game? Matrix? Icicles? Outline? I should have been more clear. Here's a mockup I did of the mounting with cardboard. I...
Tgunn wrote:Btw would be curious to see your mounting technique. I was thinking of something similar for my roof line. My thought was aluminum flat ...
DJMASTER82 wrote:Did you have any luck with figuring out what you are going to use for your roofline. I am also changing my roofline/garage door/front...
DJMASTER82 wrote:Did you have any luck with figuring out what you are going to use for your roofline. I am also changing my roofline/garage door/front...
stallionent wrote:I replaced all my strips with bullet pixels I'll have to read more on how these are mounted then. I saw the bullets and nodes and ...
scootchu wrote:Sometimes the strips make the house look like a 7-11 store. Haha yeah that is a valid point. I've seen a few storefronts with strips a...
uncledan wrote:Strip is a pain with much higher failure rates than nodes in my experience. In the process of removing all the strip and replacing wit...
I'm leaning towards strip for the house outline. I can see how other formats like nodes or bullets would be better suited to wrapping around trees o...
Ronnie wrote:I would suggest looking at some videos from folks with different lighting on the roofline to give you some idea what to start with. I use...
