Mounting bullet pix...
 
Notifications
Clear all

Mounting bullet pixels

14 Posts
9 Users
0 Reactions
12.5 K Views
th182
Posts: 159
(@th182)
Estimable Member
Joined: 11 years ago

PVC drilled with a step bit is how I’ve been doing it. My eves stay up all year with no issues. I made window frames this year with the same method.

Sent from my iPhone using Tapatalk


Reply
Posts: 16
Topic starter
(@tgunn)
Eminent Member
Joined: 9 years ago

After some experimentation I have determined I'm going to use:
2" wide strips of 1/16" white acrylic sheet - drill 12mm holes drilled with a forstner bit
4" wide strips of 1/2" plywood - drill 1/2" holes.

The 2" acrylic strips will be what the light snap into. They'll be glued to the plywood which provide support for the acrylic and have enough overlap to attach behind the fascia boards.


Reply
pmiller
Posts: 2795
(@pmiller)
Famed Member
Joined: 12 years ago
Tgunn wrote:After some experimentation I have determined I'm going to use:
2" wide strips of 1/16" white acrylic sheet - drill 12mm holes drilled with a forstner bit
4" wide strips of 1/2" plywood - drill 1/2" holes.

The 2" acrylic strips will be what the light snap into. They'll be glued to the plywood which provide support for the acrylic and have enough overlap to attach behind the fascia boards.

You might want to consider using a step drill. Forstner bit might chip.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 16
Topic starter
(@tgunn)
Eminent Member
Joined: 9 years ago
pmiller wrote:You might want to consider using a step drill. Forstner bit might chip.

Sent from my SM-T710 using Tapatalk

I have a step bit so I'll be sure to take it along when I drill the holes. It turns out it's 1/16" styrene so it's very soft and flexible. The forstner but seemed to do okay drilling the styrene but that was just a single trial hole. 🙂


Reply
Page 2 / 2
Share: