tfischer
@tfischer
Prominent Member
Joined: Nov 2, 2009
Last seen: Nov 22, 2026
Topics: 37 / Replies: 812
Reply
RE: Progress?

And... hot off the press: Roped my kid into helping me finish 4 more pixel canes. That's 22 out of 25 fully ready to go. Sadly, the final three nee...

5 months ago
Forum
Reply
RE: Progress?

Went to Menards today and while I was there, picked up two ammo cans which will become differential receiver boxes. I made two last year and they work...

5 months ago
Forum
Topic
5 months ago
Forum
Replies: 51
Views: 3522
Reply
5 months ago
Reply
RE: Icicle sequencing on pixels

MartinMueller2003 wrote: I may have to do some work to get ESP to handle RGBWW. Right now it can only get to RGBW. ): LOL that's the nomenclature Pa...

5 months ago
Forum
Reply
RE: Lynx Express Boards

teberle wrote: I took some pictures of both sides of the board and Claude analyzed the pics, and put together some points for me to test with. Curren...

5 months ago
Reply
RE: Icicle sequencing on pixels

angus40 wrote: I've experienced issues in the past with e1.31 and Wled. Plus , with the addition of tls pixels to the pixelStick firmware I have 0 ...

5 months ago
Forum
Reply
RE: Lynx Express Boards

wow, crazy that site went down. It used to be so active... Google found the document in the wiki here on this site, but the wiki has been disabled. P...

5 months ago
Reply
RE: 3D canes

I now have 18 of the 25 canes fully built, as of tonight. Got the family to help me knock out 8 more in about an hour or so. Tonight I found out I un...

5 months ago
Reply
RE: Permanent Roof LED Install and Heat Issues

I don't have any permanent lighting (save for one strip over the garage door) so I haven't had to deal with controllers in the attic. My roofline gets...

5 months ago
Forum
Reply
RE: Spotlight Resurrection Project: A Garage Wars Saga

Cool project, just catching up on this now. The discrete R, G, and B floods remind me of one of my earliest RGB projects (2008) using MR-16 LEDs. It'...

5 months ago
Forum
Reply
RE: The end of the line

Are you parting out? I need a smart receiver for sure. I'm really only needing the bare board but would consider a prebuilt one depending on price.

5 months ago
Reply
RE: Permanent Roof LED Install and Heat Issues

Of course the attic locations would need power as well, so if you were adding them up there it's just a matter of bringing those down to the closet to...

5 months ago
Forum
Reply
RE: Permanent Roof LED Install and Heat Issues

Do you have an interior closet or something where you can mount the controller and run the wires up through the ceiling?

5 months ago
Forum
Reply
RE: Permanent Roof LED Install and Heat Issues

How hot is your attic getting? Do you have good attic ventilation? The ESP32 chip itself is rated up to 125C so I don't think you're exceeding that....

5 months ago
Forum
Page 7 / 57