here are the dimensions. This is the model with the studs added i was going to use hte ones without the studs
probably a good idea
ok..........
woldnt it be easier to just set each chip for the proper id and have it pass the whole data stream
but what if you connect non renard devices in stream doesnt the dmx protocol require they recieve the whole stream and just use there bit.
this is what i was think of using firegod board for a remote sub controller that the individual ssr's would feed back to.
Is it still passing the full dmx string down the line or is it stripping it? My concern would be what if you accidentally put device out of ordercom...
You can only edit post for the first 60 minutes
It's good to be the king!! LOL
but i thought you couldn't update posts older than 60 minutes...
With DMX you could do that i think because each device get its own id.
i like the one from forum-lance but it is still not our old one..... ahhhhhh
That might be useful especially dmx so it is addressable.
I will contact the vendor to see if they have the information
Frank can you send me your PCB maybe it would just need holes installed for the stand off screws
