look in the files for that profile and see if you have a file called lock delete that
try closing the program and unplugging the programmer plug programmer back in and open program see if it finds it
not sure if you might have hurt the pic when you had it in the programmer wrong Wayne might be able to answer that for you he is smarter than I about ...
not sure why it isnt showing the device now you had it showing the device before
in that drop down select midrange and standard then close program and reopen it with chip in and see if it finds it
is the little button in the up position?
now that last pic looks like you have it in right place
did you move the chip so it is on each side and move it up 1 slot? new pic helps
look at this picture your last picture shows you still putting chip in wrong place you can click on picture it should go larger and you see the red li...
hard to tell from pic but try moving the chip up 1 pin toward the cable
ok chip is in wrong half the pins should be on the side you have whole chip on and half should be on other side of the center
can you take a picture of where you have the chip in the adapter when you try to program it?
kinda sounds like you are setting things up and using the zoom function and closing out with it in zoom mode
here is another one off the effects I used
