Steve and Anthony
@steve-and-anthony
Trusted Member
Joined: Sep 11, 2016
Topics: 9 / Replies: 37
Reply
RE: best way to mount leds onto pvc pipe?

I actually take a grinder and notch out my Tee's to maintain my 2 1/4 inch spacing. I probably should have taken a picture of one that didnt have so m...

6 years ago
Forum
PVC
Reply
RE: best way to mount leds onto pvc pipe?

I use 1/2 inch schedule 40 PVC. I drill all the way through using a 12mm forstner bit. Using this non fancy schmantzy, low tech, made from scrap plywo...

6 years ago
Forum
PVC
Reply
RE: Downstream arch incorrect twinkling

Yes, i'm sure that's what it was. But it was so weird that everything worked fine on the "bad" arch, and only sent a screwy signal downstream. I kept...

6 years ago
Topic
Reply
RE: Advise on battery operated color furniture

At 5V, .06 Amps/pixel, 8 pixels, at 50% brightness, for 15 hours, will need about 3.6 Amp-hours. You could probably get away with one of those USB po...

6 years ago
Reply
RE: Advise on battery operated color furniture

Here is some info on battery sizing that you will need. 50 pixels at 12V use 36 Watts or 3 Amps. For 15 hours 50 pixels will required a 45 Amp-hour ba...

6 years ago
Reply
RE: New Video: How I do my Christmas Lights Tutorial

OK so it's nowhere near complete, but my website to support how I do my Christmas Lights using the Falcon 48 Controller, Differential Receiver, 5V WS ...

6 years ago
Reply
RE: New Video: How I do my Christmas Lights Tutorial

Hey Curtini, Off the top of my head, I cant think of anything wrong with using 3 pin for power injection. As long as you continue to use the same col...

6 years ago
Reply
RE: RGB "Outlet plug"

Just having a standard 3 pin connector coiled up inside an outdoor electrical box like this seems like a cheap and easy way to do it. Are you gonna...

6 years ago
Reply
RE: Will 1/2" (usually) grey schedule 80 pvc conduit work well with pixel bullets?

Re: Will 1/2" (usually) grey schedule 80 pvc conduit work well with pixel bullets? 2 3/4 inches plastic bottom of the bulb to plastic bottom of the b...

6 years ago
Reply
RE: New Video: How I do my Christmas Lights Tutorial

Curtinti....Makes me so happy that someone is finding benefit in my Tutorial. I really wish a tutorial existed like mine when I started my journey 🙂 ...

6 years ago
Reply
RE: Will 1/2" (usually) grey schedule 80 pvc conduit work well with pixel bullets?

Re: Will 1/2" (usually) grey schedule 80 pvc conduit work well with pixel bullets? I dont know about the grey schedule 80 pipe, but as far as drillin...

6 years ago
Reply
RE: MTM Ammo Enclosure Question

I use this one from Amazon I use it with a differential receiver and 5V 22 amp power supply, enough to power 200 pixels (50 per receiver channel). ...

6 years ago
Reply
RE: How do I set up an Xlights practice setup and layout

Oh i got it, so i just create a new show directory for practice and point to that, and then when done change back to my original........... works. Tha...

6 years ago
Forum
Topic
Page 1 / 4