Activity
 
Notifications
Clear all
slug
@slug
Reputable Member
Joined: Dec 23, 2007
Topics: 50 / Replies: 132
Reply
RE: Olsen 595 PCB Board(s) WANTED

I may have a complete one with the REN-C and REN-T. I'm not using it, but I have to find it. I also have an unused board, and some of the parts.

14 years ago
Forum
Reply
RE: Small Pixels or Dumb strings

I'm just looking for form factor. The TLS 3001 are single nodes on string, but they are a little big.

14 years ago
Topic
Replies: 6
Views: 2377
Reply
RE: TLS 3001 Pink Hue ?

I posted some pics of the ends in this thread.

14 years ago
Reply
RE: TLS 3001 Pink Hue ?

three at the beginning, and two at the end, which is correct. That will connect the ground and data to the next string and allow power to be injected...

14 years ago
Reply
RE: TLS 3001 Pink Hue ?

I'm trying to remember what the two wires are at the end. I'm thinking only ground and data. So, I would have to figure out how to inject from the o...

14 years ago
Reply
RE: E682 Question: How many "Sequence Errors" are normal?

Had a bunch of sequence errors until I spent a little more time trying to understand. I had to fix my universe numbers and then assign the starting a...

14 years ago
Reply
RE: TLS 3001 Pink Hue ?

I'm not that concerned with it at this point. At least not enough to tear things apart to measure. I was just curious. Everything is working. I'm ...

14 years ago
Reply
RE: TLS 3001 Pink Hue ?

350w. I'm only running 6 strings of 50 off this controller. Edit to add: that is with just one of the strings being tested. I don't have all of th...

14 years ago
Topic
Replies: 14
Views: 4044
Reply
RE: ren64xc Input Swap, whoops

They must have just been tired. I swapped them out and it all started talking again. I wasn't really in the mood to re-flash all the pics, so I jus...

14 years ago
Forum
Topic
Forum
Replies: 3
Views: 1607
Reply
RE: Scosche FMT4RA Hack/Mod

I tried this and the unit wouldn't power up. I only had a 680 & 180 ohm resistors in series. Could this have been my problem. It powered back up wi...

14 years ago
Forum
Reply
RE: REN48LSD Problem

The jumper from the resistor to pin 8 didn't work. I still didn't get any reading across pins 5 - 8 after it was installed. I've switched over to so...

14 years ago
Forum
Reply
14 years ago
Forum
Page 7 / 13
Share: