se7enred7
@se7enred7
Eminent Member
Joined: Dec 7, 2010
Topics: 2 / Replies: 15
Reply
RE: Electrical Engineers out there?

The company I'm with hires a few EE/ME interns over the summer, mostly from UNLV. The pay is in the $16-$20/hour range.

16 years ago
Forum
Reply
RE: Renard SS Interest Only

3 SS24 PCB & BOM 6 SS24 Heat Sinks

16 years ago
Forum
Reply
RE: LED Full Wave / Half Wave Rectifiers

Doh! I neglected that there is a stack of diodes, and not just a single diode. So power would be dissipated only over a fraction of the wave, with the...

16 years ago
Reply
RE: LED Full Wave / Half Wave Rectifiers

If you convert to a full wave string, the resistor (and led's) will dissipate twice as much power as with a half wave. The resistor value does not nee...

16 years ago
Reply
RE: The Renard SS 24 is now available! (first post is current 9-17-2018)

Re: The Renard SS 24 is now available! (first post is current 1-1-2011) Last month, the Triacs were were significantly less on alliedelec.com than on...

16 years ago
Forum
Reply
RE: Circular connectors on enclosures?

Thanks for the insight Aurbo. The unit will definitely be less versatile with the circular connector. Two circular connectors would run me over $50, b...

16 years ago
Reply
RE: Circular connectors on enclosures?

Thanks gator. If something goes wrong in the center of the connector, the repair will definitely be frustrating and tedious.

16 years ago
Reply
RE: Circular connectors on enclosures?

Yes, I am planning on soldering the light strand wire from the minis directly to the connector. I'm not thinking heat will be an issue inside the circ...

16 years ago
Topic
Replies: 15
Views: 6031
Reply
RE: GAH! 2 out of 3 non-BOM items incorrect.

I don't intend to be contrary. I'm new here and don't want to wear out my welcome 🙂 My reasoning could be flawed, but as I understand it: If the con...

16 years ago
Forum
Reply
RE: GAH! 2 out of 3 non-BOM items incorrect.

F connectors are 75 ohm characteristic impedance, but will read 0 ohms on your ohmmeter.

16 years ago
Forum
Reply
RE: GAH! 2 out of 3 non-BOM items incorrect.

F-type connectors are 75 ohm while sma connectors are 50 ohm. You could get reflections back into your transmitter as well as less range.

16 years ago
Forum
Reply
16 years ago
Forum
Reply
RE: Choosing an FM transmitter

Macrosill, there wasn't really a question in the OP :/, it was just kind of a conversation starter. I've read that many are using the FM25B, and are ...

16 years ago
Forum
Reply
RE: Choosing an FM transmitter

Great idea! I didn't want to spend $50 on n-type attenuators.

16 years ago
Forum
Page 1 / 2