RStetson
@rstetson
Eminent Member
Joined: Nov 13, 2008
Topics: 5 / Replies: 29
Reply
RE: Walmart to huge discount today

I picked up 40 boxes of 100 ct minis for 23 cents a box and 20 200 ct minis for 1.18 a box at Walmart by me today. I asked the sales girl about more r...

18 years ago
Forum
Reply
RE: Lights work in reverse????

Yeah I got the Grinch out ports all correct. I do believe, from using a meter on it just now, that the cable from the pc to the Grinch is wired incorr...

18 years ago
Forum
Reply
RE: Lights work in reverse????

Thats just it. When I used the grinch troubleshoot wiki it says not to attach a test sequence to a profile. So I just made up, like it says, a 20 seco...

18 years ago
Forum
Topic
Forum
Replies: 10
Views: 4518
Reply
RE: I'm doing something wrong I guess....

Well just when your ready to throw a huge hammer at everything a light always comes on! LOL We have 2 printers in the house. They both connect from US...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

Yes I have a profile for my normal sequences but the troubleshooting section on wiki says not to attach your test sequence to a profile and just run i...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

Can someone correct me if I'm doing something wrond with Vixen. I have the Olsen 595 plugin only and its setup for 1 - 64 channels. Then I go to seque...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

Well just for the heck of it I put Vixen on 2 other computers and get the same readings right out of the printer port on teh back of the pc without an...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

I'm getting above 5v, like 5.11, from my power source. When I do mt meter test at the printer port on the pc I get a reading of 4.78. Rick

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

I'm running extternal power to the board. The problem has been traced back to no info out of the printer port. In other words when I run vixen and do ...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

I get no power changes directly from pin 2 on the back of the computer. So obviously the problem now is internal with the pc and not beyond that point...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

When I run Vixen all I have to do is run the sequence in playback mode correct? There isn't another way to make it work that I'm not doing is there? ...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

Ok I do believe I offically and totally give up! I can't get any data to the Grinch. When I run the trouble shooting test where I run a test sequence ...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

Ok narrowing down the possible causes here. I took the Alegro chips out of the Grinch. Then using a small wire touched pin 1 to pin 5, 6, 7 and 8 and ...

18 years ago
Forum
Reply
RE: I'm doing something wrong I guess....

Well I did away with the 595 simple and went with the Olsen 595, I read that in another thread. Still just get lights on full all the time on channel ...

18 years ago
Forum
Page 1 / 3