Could I replace the triacs in the standard COOP SSR setup of MOC3023 and 180 ohm and 750 ohm resistors with this TRIAC? I would only run 4 amps on ...
Boy those are pricey! Is there an off brand option? how do I search for the random-crossing option? I am looking on mouser or digikey, but I can't fig...
shoot... I found some old threads with links to eBay for dimmable ones, but they are all so old ebay doesn't have the listings anymore... Hopefully s...
Hmmm..... Well I'm not getting 5V anywhere but the main 5V power for the LED's on the coop SSR boards... I get about .20 volts when the channel is on...
Phil: Does it help if the triacs aren't actually hooked to the same outlets? so the neutral AC side would be hooked together... but the Hot sides tha...
which 12 amp triacs do you use? are they a drop in replacement for the BTA08-400B? do you have to change resistor values? that may be a good option f...
yes, that can work too... if I had that many channels... I am using almost every channel I have already... I do have some daisy-chained SSR's as well...
And the limit for most SSR designs on this site (without heat sinks) is 1 amp per channel. So back to the previous question... Phil?
ooh! I know that one- a single typical 100 bulb 110VAC mini light set draws about .3 amps... so 3 strings to an amp is approx.
Great point- I am not using a standard copper board for this- I have beefed up the AC amperage capability with 10 gauge wires instead of copper traces...
How many of the crydom SSR's do you have left?
