pixelpuppy
@pixelpuppy
Honorable Member
Joined: Jan 16, 2015
Topics: 21 / Replies: 651
Reply
RE: Wireless Show Network

MartinMueller2003 wrote:the ack that is generated in response to receiving a unicast PDU has little to do with the L2 ack (that releases the AP transm...

6 years ago
Reply
RE: Falcon F16 vs F48

DrNeutron wrote:I like to use several smaller controllers strewn about the yard, so if something happens with one I only lose part of the show. Ditto...

6 years ago
Reply
RE: Wireless Show Network

kenoman742 wrote:...The 8 pixel sticks also run well on multicast and that will continue to be my plan as most opinions on multiple forums claim they ...

6 years ago
Reply
RE: Wireless Show Network

The intended purpose of Multicasting is for when multiple clients need to receive the exact same data (e.g. streaming video). But that is rarely the ...

6 years ago
Reply
RE: Wireless Show Network

Is the Remote Pi a long distance from the Access Point? Have you tried using the Pi's built-in WiFi to connect to the AP (without having to go thro...

6 years ago
Reply
RE: Wireless Show Network

Is the Remote Pi a long distance from the Access Point? Have you tried using the Pi's built-in WiFi to connect to the AP (without having to go thro...

6 years ago
Reply
RE: At an impass with FPP, F4V3 and Xlights

Also, check out the FPP Manual. There are some good examples of different network configurations starting around page 96

6 years ago
Reply
RE: At an impass with FPP, F4V3 and Xlights

Sounds like an IP addressing issue. We need to know the IP addresses (and mask) that you are using for FPP and the Falcon and the subnet address fo...

6 years ago
Reply
RE: Charming from laptop to Raspberry Pi

wilmar wrote:Thank you for the pi do you know if it has the rtc or not ? By itself, neither the PI nor the BBB have built-in RTC, but there are vari...

6 years ago
Reply
RE: Charming from laptop to Raspberry Pi

A Pi3B+ is more than sufficient. A Pi4 will work too but its more than FPP needs and it uses more power and generates more heat.....if that's somethi...

6 years ago
Reply
RE: Setup P10 Panel Elements

The problem is those two controllers before the BBB are assigned 36 channels (24 channels on the 1st one, 12 channels on the 2nd one) which is equal t...

6 years ago
Reply
RE: Setup P10 Panel Elements

Looks like the starting channel is off by 12 pixels. What's on the two controllers you have listed before the BBB in the Vixen Controllers setup? ...

6 years ago
Reply
RE: Raspberry Pi and what else?

angus37 wrote: pixelpuppy, I'm curious - do you use a Pi in your setup? Do you use it as we are discussing here or in some other fashion? I use mult...

7 years ago
Reply
RE: Falcon F48 with Vixen

jmassaro87 wrote:Right, just wasnt sure if the F48 was any different being that it is self only has 12 outputs, that output to the receivers that have...

7 years ago
Reply
RE: Raspberry Pi and what else?

piense wrote:The reality of the Pi is that it can't reliably control large numbers of pixels .... Well that depends on what you consider to be a "lar...

7 years ago
Page 2 / 45