It's really helpful to post photos or video of what you are seeing, or better yet, post your files for someone to look at. The files that are generall...
The pixlite 4 does, so I'm sure the 16 does as well. I can't remember, but it's one of the two buttons. Hold for 3 seconds to initiate. Sent from my ...
What happens if you run the onboard test from the controller? Sent from my Pixel using Tapatalk
Another good controller is one of the falcon boards, pixelcontroller.com. They are arguably the best board out there now. Joe Hinkle just released a b...
If it were me, I would just start over. Did you post at the falcon forum? Sent from my Pixel using Tapatalk
Everything comes from China. HolidayCoro may have a different vendor than Ray, but they are still in China. I prefer to support people US based. So, b...
I use all unicast and I'm able to test just one or two controllers at a time. There may be lag, but no data, not sure about that. It may depend on th...
cgulls123 wrote:Thanks for the advice. I don't see an option for a video mapper. Where would I find that option? I think under tools... going off o...
Also, create a new sequence and test just those lights to isolate any issues with your sequence. Sent from my Pixel using Tapatalk
Or use a custom model. You can specify which nodes to use, or not. You can easily skip as many nodes as you need. Sent from my Pixel using Tapatalk
Use a custom model. I would use the video mapper since it sounds like you have it wired up. Sent from my Pixel using Tapatalk
I believe the developers wrote code to scale or compensate for the preview. So, I don't think you can judge by the preview. Sent from my Pixel using ...
Yes, but I believe it's based on models. So you would have to do it for each model. Could get time consuming. Sent from my Pixel using Tapatalk
Don't believe that's possible with your controller or your model. It can be done with a falcon controller and you could do it with a custom model. Wh...
