XLIGHTS and Spinner
 
Notifications
Clear all

XLIGHTS and Spinner

5 Posts
2 Users
0 Reactions
2,947 Views
Posts: 4
Topic starter
(@cgulls123)
Active Member
Joined: 11 years ago
[#43567]

Everyone thanks for the help in advance. I am a new user Lakeville MN. I was in a rush to get a new spinner out before the snow and I took the easy way out on the wiring. Here is my wired spinner:

Nodes 1-25 running from South to North, 26-50 West to East, 51-75 Northeast to Southwest, 76-100 Northwest to Southeast.

My question is how to setup in Xlights to get the spinner to work as expected when sequencing since my wiring is unconventional? I am new to the advanced setup/sequencing and would greatly appreciate the help!

Thanks in advance
MEG


4 Replies
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

Use a custom model. I would use the video mapper since it sounds like you have it wired up.

Sent from my Pixel using Tapatalk


Reply
Posts: 4
Topic starter
(@cgulls123)
Active Member
Joined: 11 years ago

Thanks for the advice. I don't see an option for a video mapper. Where would I find that option?


Reply
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago
cgulls123 wrote:Thanks for the advice. I don't see an option for a video mapper. Where would I find that option?

I think under tools... going off of memory.

Sent from my Pixel using Tapatalk


Reply
Posts: 4
Topic starter
(@cgulls123)
Active Member
Joined: 11 years ago

Thank you. I will give that a shot. My spinner lights up and works but won't behave as it would normally. Just another example of a Noob trying to get fancy! 😉


Reply
Share: