Activity
 
Notifications
Clear all
neophaetr
@neophaetr
Trusted Member
Joined: Jun 29, 2008
Topics: 17 / Replies: 48
Reply
RE: LED group buy

Depending on the ability to dim and whether or not they will last more than two seasons, I will purchase a fairly sizable amount. However, it will be ...

17 years ago
Reply
RE: Helix 32Ch SSR Daughter Board

Im in for two kits...keep me posted, if its not too much trouble. Thanks for your time and energy on this board.

17 years ago
Topic
17 years ago
Forum
Replies: 0
Views: 1826
Reply
RE: well...I may have fried my first triac

i assume you are talking about the ren64 and the ssrs

17 years ago
Forum
Reply
RE: well...I may have fried my first triac

the boards were dry as can be when I ran my first test sequence.

17 years ago
Forum
Reply
RE: well...I may have fried my first triac

good news... i did not fry the triac! But, I do have another problem. I have two ssr's with one channel each that either does not light up or it stays...

17 years ago
Forum
Reply
RE: well...I may have fried my first triac

I let the ssr cool through the night... I will check it again tonight but if it doesn't work, I guess I will be forced to send in my "second string". ...

17 years ago
Forum
Topic
Forum
Replies: 14
Views: 5452
Reply
RE: SSR problem?

I too have noticed a problem regarding the ssroz. One channel does not light up on one ssr but will on another ssr. Could this be a faulty moc3023?

17 years ago
Forum
Reply
RE: renard 64xc serial port problems

thank you and I thank everyone who has guided me in the direction of the blinking lights.

17 years ago
Forum
Reply
RE: renard 64xc serial port problems

My board works!!!! I got it!!! it was a crossover cable!!! ha...MY Board works....ITS ALIVE!!!! MUAH HAHAHAHA

17 years ago
Forum
Reply
RE: renard 64xc serial port problems

no dice on the jumper. you know what... it could be the cable! When i built my board, I used a male db9 connector...what I had lying around. Could t...

17 years ago
Forum
Reply
17 years ago
Forum
Reply
RE: renard 64xc serial port problems

I am connecting to ren xc using serial cable. Pardon my question but isn't that rs 232? I just put the board together according to the BOM so I have n...

17 years ago
Forum
Reply
RE: renard 64xc serial port problems

i rechecked my settings in both vixen and device mgr...they are the same. 57600, 0 parity, 8 bits, 1 stop bit, hold open during sequence, and protocol...

17 years ago
Forum
Page 1 / 5
Share: